Search results

If you cant figure the flash part you can take a ten ohm 10 watt resistor and thru a relay tie it into the same circuit then on input side you tie that to the small wire on starter what this does is apply a small voltage to the field while cranking and its usually enough to flash the gen...

Also a quick and down and dirty check can be done by remove the small two pin connector coming from the gen head going to control box and while running touch a 9 volt battery to the two pins on gen side , voltage will jump up , this flashes the gen and checks all the generator parts at same time...

You can use a tiny tach module that's is used for lawn mowers etc. I made a airboat with a 4a084 and all you do is wrap the pickup wire around sparkplug wire. Show hours when not running and rpm when running has built in battery thats last about three years and waterproff. Amazon or eBay!

Sorry double post! If you need I got complete MEP003 rotors with the diodes and bearings new , I need to get rid of, got over ten and want to quit tripping on them Ill sell for 100 bucks! Marty

If you need I got complete MEP003 rotors with the diodes and bearings new , I need to get rid of, got over ten and want to quit tripping on them Ill sell for 100 bucks! Marty

set of each! if drums are the same front and back ill get one set with drums.

Anybody driving a MV from Louisiana or Texas to Rally? If so what route?

Steve I will probably take a set of backin plates I need some spare brake canisters! marty

Would like Lmtv cans! Marty

Looking for some M939A2 inner hub seals if anyone got any, and inner seals for lmtv, and I will be bringing new UNIMOG SEE injection pumps and MEP002 or MEP003 injection pumps NOS, probably some MEP002 Generator ends (stator)sometimes called stationary field and MEP 003 Rotors (the rotating...

I got some new mep 002 stators only In crate if you Need that part don't have the rotor part though !

yes but thats the only picture so far, I can get another once it stops raining been raining for days here! Aircraft stripper and alot of buffing!

Edited but I am from Louisiana so I did my best!

The Mrap Caimen aluminum rims that have the same bolt pattern as a standard m939 truck that are made by Hutchenson WI-1184 do fit the LMTV without machining. The M939 as in my M927a2 series truck you have to machine the lug nut taper using a 82 degree countersink on the reverse side of the...

Al if you get this done, name your beer it will be delivered!

I agree on the start over but i believe they will need guidance and education on what we the people are trying to accomplish! We as a whole community of collectors/users need to help educate the politicians.

After reading the other states Bills (Virginia and OHIO) it looks to me that Hewitt took almost the exact info off of the Virginia Bill basically copied and pasted,, but left out the specific definition of the (Military Surplus motor vehicle) as defining it as a HMMWV part in the Virginia Bill...

In between the frame rails under camper welded to the floor cross members. 100+ water think 30 gray 30 sewage. look at pictures carefully.

Darn should of read about this earlier I'll be in Jacksonville Tx. to that weekend at Mud Nationals.

Your vehicle does not have a NHTSA label because the NHTSA did not exist before 1970. That should help Also , Here's the email may help! Tabitha.Ducote@la.gov