Search results

That varies state to state also , here in michigan it needs a attached stove and bed also.

Generally federal courts rulings only apply to the district it is filed in unless it involves more court districts or a ppeals court rules different . The "right to farm act" is one of the ways around zoning .

Different city different state , all that matters is the zoning laws where the violation is and how they are wrote.

I'm unable to expand your photo's but if you are in a city they most likely have zoning laws your violating . I know here they have designated truck routes and anything over 22 foot or 10,000 pounds is restricted except for deliveries . And heavy equipment needs to be stored in areas with...

I'm in mid michigan near the Saginaw Bay . But there are a lot that are not driven year round . People may be asking 20K on ebay , but I doubt that very few actually sell for that even if they show sold .

I would say more in the $6000-$10,000 range here in michigan for a really clean one .

I just thought I would throw this out in this thread ( it really doesn't matter at this point since michigan don't allow HMMWV's) but michigan has a 2 inch max body lift law . I'm sure that other states have similar laws , so this should be factored in what your state law is and stay within it...

It was a Long time ago you bought anything , when I bought my deuce from GL in 2009 ( out of Selfridge AFB ) it was $60 for the SF-97 and you had to pick up the truck before you order the SF-97.

A little bit of heat from a propane torch will melt the plastic out . it will come the hole they inject it in .

The ones on the truck are probably factory u-joints and injected plastic holds them in , the replacements use the clips to hold them . You know save a penny during production using plastic. Should be covered in the TM.

It is a seal ; https://www.classictransmissionsolutions.com/linkage-seal-th350-th400-700r4-transmission-manual-control-selector-shaft-shift-always-free-shipping/?_vsrefdom=adwords&gclid=EAIaIQobChMI596onuXG9wIVvhXUAR3wtgWnEAQYASABEgKjTPD_BwE

I-75 & Dixie exit 144 Bridgeport Mi yesterday .

Who isn't doing anything ? Patracy is addressing the problem . And from how this site was run before he volunteered to take over as Admin He is doing really good job of addressing problem's as they come up . You haven't been here long enough to know how screwed up this site was prior to him...

I've had good results with Aero Kroil , but most people won't spend the money

I think everyone should realize there has been scammers on this site as long as it has been around , Darrel Braun , Indyfab4x4 come to mind , it's just they were weeded out much faster and technology wasn't as good in aiding them when there was 10,000 members compared to 100,000 now . Anything...

The biggest issue with just swapping the pads is you are putting new pads on heat glazed rotors witch will glaze the new pads . You really have to clean them up and make sure there are no ultra fine heat cracks or warpage . edit; spelling

Is this for a shortened M35 bed ? If so it's probably a very limited market since most people use M105 beds and racks & troop seats are readily available for them .

Around here it's about $15-25 a rotor , but not many shops left that turn them . Just swap for new china crap.

The minimum thickness should be on the rotor someplace .