Search results

Lookig for the operating PSI and GPM and pump frame specs for the hyd. pump for the m62/m246/m819, I think the m60/m108 uses the same pump but not sure, I have the AW tm, it does not have the pump specs. nor the pump frame specs.

Why not get a BIG rotating wrecker, just lift and load, this is pretty much how everybody does it, how we did it in FL., if you have access to a loading ramp, you could cage the brakes and have a fork lift work it onto the trailer, this would be a hassle but doable.

Turn in the fuel shut off seleniod over ride thumb screw, this will bypass the batteries, will need to use the emg shut off to shut down the engine, then jump across the starter selenoid. The above WILL start the truck, what else is wrong is up to you

If this is the type of WORKMENSHIP that went into this bob build, I would If I was you, look at the rest of the build VERY CLOSELY

I would like to have the bed, mount it on a 936 or 816 frame, scrap the OE frame, doing away with all the electronic crap, would be a GREAT wrecker,

No, once installed on the m819 stays on the m819, waiting to talk to Hewitt, what did your 010-213-xx-x, cost, this looks like what I am looking for. I was referring to it did not matter what volt the bulb in the cauge came with, it could be changed to what volt was needed.

Just smack them out with a BFH and replace them with NEW, the old ones are just that OLD, might even be OE, who knows how much they are stretched, If your putting BIG, OVERSIZE tires on, NEW studs would be the safest thing anyway.

Welding to the shaft could cause heat cracks or fiatigue if the shaft is heat treated, either of these conditions could cause a failure over time.

Still looking, found one that is mechanical but needs 12v for the leds (not a big deal, can pull off one battery), I am looking for the OLD still (some of you guys are old enough to remember) mechanical pointer with a simple bulb for illumination that can be changed for what ever voltage needed

A little greet/meet to show off our trucks and make ALL the kids young and old happy

No truck needed, just show up, camp or not, BUT what ever there will be a OVER LOAD of fun and good times and a LOT of GREAT people

I can see little BS meets with guys that are close to each other, then the 13SSGAR and ZOUTS bbq for a big/big get to gether, this is one reason I posted touch-a-truck, it is a small, local thing.

Hi from Gainesville

No, we WILL get a driver

Gainesville has TOUCH-A-TRUCK the 10th of AUGUST, see link below http://www.steelsoldiers.com/showthread.php?103999-Aug-10-TOUCH-A-TRUCK-Gainesville-Ga

Depends where this happens, I could see a wrecker or two showing up

As the title says, Gainesville, Ga. is having it's annual TOUCH-A-TRUCK Aug.10, I know that 2 wreckers and a wheel chock (m1009) will be there, maybe we can get a bunch of ARMY trucks, the KIDS of ALL ages just love them. When I took the 819, there was a line to visit while the MACK dealer got...

EXTRA, LEAGAL Vin and ID data plates are highly sought after by GOOD scrounging SGTS.

if there are not spacers on the rears then the hubs are wider, the 1400 duels will not fit without major rub problems unless either the spacers or wider hubs are used

Just cut a hole in the floor