Search results

This is after I cleaned it up a little

Hello everyone I got a 1971 m35a2 with 8000 miles. It has a white 465ldt D it is dated Feb 1986 on the plate it has the tab style head gasket with a C turbo. I just adjusted the valves on the truck but this was going on before. it has the Ann 130sm 6844B2 injectors the truck starts good hot...

Hello and welcome from South Carolina

Tighten it up still acting up. Out on a 40 mile round trip now

That's the 1st thing that popped in my head when I first felt it. Sure enough I come wiggled the back mount behind the starter Sure enough it is lose and I can giggle it around

I just had that plate off the other day just looking around nothing fail out and surprised me lol. but I didn't run the truck I will do that next maybe tomorrow and see what happens. It just like the pedal I wouldn't say soft it's more like it catches at the bottom then the next time it catches...

I got a 1971 m35a2 and when I drive it on the road in a straight line the clutch is nice and firm. Now the real ? When I turn in say a driveway and smash the clutch it feels really low and less pressure but once I straight up and go on it goes back normal and gets back firm any ideas clutch...

www.boyceequipment.com try these guys I really don't know that much about m925a2 I spend most my time on m35a2

Yea that would be a pinion seal. Sorry i dont know any real tricks. Try this guy www.bigmikesmotorpool.com

Hello and welcome from South Carolina

I'm around charlotte nc on the map if you need anything when you passing through with the truck

Try going on Fox 8 news and getting the number and give them a call and see what they say

Can yall share a post on here for the one I can post on Facebook

10-4

Anyone got any word on the the trail ride is going to be like? What do we need to expect?

Mine is the old style with the weep tabs

Hey I got a quick ? I welded a wrench together photo inclosed. Being the angle that is on the extinction does that effect the length that I enter into the calculator on the post on measure E do I just measure on the bottom of the tool from the center of the wrench to the center where the...

Welcome from South Carolina

Well I just went and looked and my brand new wheel cylinder is leaking going to wait a few days and see if it stops

I'm pretty sure mine is run together like that I need to separate mine as well