Search results

I don't think the trans is the same,not shure about the case.I take it You got the water truck?

I have 4 or5 of the 20" beadlocks. You can have them,pick up only. PM me if You want them.

Me Too! :ditto:

I will be needing a new Hydraulic head,I checked the torq on the plug and it seemed loose so I backed it out and it is toast.also I pulled a nozzle, it looks bad.The end is kind of pitted and one hole is plugged.

Well the air filter is new,the turbo has a loud whistle so i assume it is turning.I am going to pull an injector nozzle,and re torq the plug. If I had a bad injector would that cause a leak in the head?

Ok ,I know it has ben gone over before.But I can't find it. I have an IP that apears to be leaking from the 12 point plug in the hydraulic head.A little info..It will not leak at idle or high idle,only under load.it has good power in 1st thru 3rd. 4th is a struggle to 5th.about now the fuel is...

Not to hi jack your thread ,but I have a set of these also.They are not as nice but have good tread, some 90% . I am also looking to get rid of.

Yep ,that is the beast. You don't have an extra do you?

Does anyone have or know where to get an ether atomizer for the deuce ether injection kit.I have contacted several manufactures and have limited success.I tried Napa and some local parts stores with no luck.Napa told me that due to the newer diesel regulations they were being phazed out.

One of our old JD farm tractors had a propane kit.Looked like a barbeque grill tank that sat on the front weights.It was enough power to rip out the rear end! I dont know about any cooling effect though.

Is there anyone near there? Please PM Me. I may have an item there to pick up.

Last chance,leaving in the AM.to pick up trailer.

I will be going to Wright Patterson AFB in the next week or so.If any one has an item they want looked at or medium item picked up let me know.

I would be very cautious in using that setup on the highway.I don't know what the clearance between the two rear duals would be.It could cause them to rub together and blow out a sidewall.The Ford truck from usa6x6 should NEVER be driven on the road.... Sometimes good looks and kool can over...

Too bad I don't have a tow rig to haul it .I was just in south central Tn.

David Doyle once again has brought out the "truth of the matter" I hear of guy's buying and selling and making big profits.If You get down to it 5-10% is a respectable profit.If these guy's actually did the numbers and included their time they would see that "big profit " is just a myth.Your...

Nice Truck ,I think I was bidding against You! I would not go-it alone,having a helping hand is safer and more fun! It will take You half the time to get it ready for the trip and sometimes they will remind you something you forgot.

So, where can a guy buy a new hydraulic head ?

I did the twist and wiggle when I pulled my pan.Then I happend accross a thread by recovery4x4, basicly it said to jack up the front frame rails.I did it, slipped right on.the problem with wiggling it back on is keeping the gasket from getting damaged.

I think M1075 knows where to get them, But the best seal is a tube.my2 cent.