Search results

Digital Dakota SGI-8E Tach interface, tap into either gen 1 or 2 (they both have the post), or tap into the brown tach signal wire on the diagnostic port. (gen 1) . You can then wire in any gasoline electric tach, follow the instructions, and bingo rpm display in a CUCV. Here is my setup.

Brand new reproduction from LMC, all 3 would run $86.00 before shipping. You would still have to paint them. Also the grille would not have the cut outs for the slave plug and BO drive.

They are both available on ebay, however the cap comes with the complete filler neck.

Welcome aboard. Start here and double check your 12V conversion wiring. http://www.steelsoldiers.com/showthread.php?75505-CUCV-Wiring-Diagram-color-(except-M1010)

4 bolts to pull and a rachet stra to hold up. No worries.

Radiator APDI 8010607 $170.00 ebay fits like a glove

http://www.steelsoldiers.com/showthread.php?75505-CUCV-Wiring-Diagram-color-(except-M1010) Start here.

When I got my M1009 both alternators were installed and the compressor was on the drivers side. The vehicle had been half way converted to 12 volts. The drivers side alternator was mounted piggy back onto the compressor brackets. I removed this alternator and completed the 12 volt conversion. I...

I had the rear windows on my M1009 tinted with limo tint and the front doors are the legal Texas limit. as far as 35% reduction in heat, well I don't know about that the fiberglass top gets so hot you can't keep your hand on it. The previous owner installed a headliner in the cab area and it is...

The compressor mounts on the drivers side below the alternator. Isn't the turbo on a 6.5 on the passenger side?

I installed the kitfrom ackit.com in my M1008. However I also converted the truck to12volts and a single alternator, so I used the kit for a standardchevy truck with a 6.2L . My M1009 has a nostalgic kit that was installedby the previous owner.( I had to redo most of the installation) These...

New 6.5L 6.2L Water Pump Plate Assembly 2930-01-147-8555 , 14024208 12562637 ebay

Looks like the 30 amp units I used to make my head light high / low beam wiring harness.

The pump pushrod will sit quietly lodged against the cover plate and cause no harm.

Ha Ha , I didn't see that.

Testing a picture upload.

Mine fit perfectly. New isolators are a must when replacing a radiator. And for proper cooling the thermostat and fan clutch are equally important.

"A good radiator shop". Few and far between, and the cost is the about the same. Embrace new technology, the new radiators are far superior to these old archaic relics of the past.

One of the most popular auction sites was my choice for a replacement radiator. APDI 8010607 $170.53 with free shipping. Thirty year old radiators should be scrapped. There I said it, flame away.

Go to "My Account" on GL you can view your invoice from there and it will state This Invoice Is Pending EUC Approval. Then right click on it and save a copy to your computer.