Search results

Eric has outsourced a couple jobs for me in the past when he was unable to haul my items. The guys he lined up did a great job for me also. Would use him again!

I have been running 33/12.50-15 BFG's for 40 years on GM 8" rims with no problem, 10.50's should not pose any problems either. I have them at 35lbs for highway driving. I get even wear. On the 1/2 ton pickups I run a couple lbs less in the rear if running empty bed most of the time.

Welcome! A couple links for you to enjoy. http://www.youtube.com/watch?v=4CpbZxVzqDc&feature=player_embedded http://www.youtube.com/watch?v=bNB1onHrXRo

It is an improvement in all categories except fuel mileage. Lots more power. Around me gas is a lot cheaper than diesel right now so that helps offset the lower mpg. The motor bolted right up to the T400 transmission. I changed to a 454 water pump and the huge oil pan to car/light truck...

The motor won't look so cramped in your engine bay after taking off the non-essential items. 366 in my M1008.

Couple from the net.

Move the vehicles! :mrgreen:

A couple pics as sold.

Not dump unit mounts. Likely setup for gin pole.

The Canadians had good success with the MT643 behind the Detroit in their deuce trucks.

I have installed heaters in many trucks using new kits to whatever will work. I really don't need the cabin heat as much as needing the defrost feature. Need to keep ice off the glass in order to see. I mount my units like some others on SS to conserve space and make it easier to service the...

This place has those trucks/parts. Their ad list in second link. http://adelmans.com/ PHONE: (330) 456-0206 FAX: (330) 456-3959 NATL. WATS: (800) 643-2001 http://rockanddirt.com/dispads/0000856815.pdf

http://www.steelsoldiers.com/showthread.php?30676-Spare-tire-on-front Some spare tire location discussion in linked thread. I always ordered my GM trucks with the "inside the bed" mounting hardware. Carried my spare in other locations also.

Someone intalled this in an older MV. I don't remember who or what model truck.

added pic Looking good! Real nice work. I'll be watching your progress for ideas in case I decide to do this to one of my trailers.

Almost time!

Addition to old thread. Noticed the lights added just below the originals on this trailer a while back in a DRMO lot.

Been discussed before. http://www.steelsoldiers.com/showthread.php?16728-Anyone-interested-in-a-lock-for-the-KILL-SWITCH&p=326856&highlight=battery+switch#post326856

Been discussed before. http://www.steelsoldiers.com/showthread.php?32122-Making-your-truck-a-tank-or-converting-your-Deuce-to-a-tracked-vehicle http://www.steelsoldiers.com/showthread.php?96595-Halftrack-Deuce&p=1238407&highlight=#post1238407

There are different sizes of picks. Most are flats with a varied width to fit the lock slot groove in the connector. Some are very small and I use a thin round to reach the terminal lock. I use a barrel pick for the weatherpack terminals. Some of the ones I use pictured here.