Search results

What tranny fluid could possibly cost $65.00 per qt!?

Back to our regularly scheduled program!:D

That's nice roof rust!

Have you had your injectors pop tested? They may be worn out and leaking.

One of the mods I made recently to my deuce tractor that I appreciate most is comfortable seats! These seats are out of something military, not sure from what. I bought the seats with springer base adapters at the 2014 GR and installed them before the trip back to Fl, Huge improvement!! Another...

Apparently so! This is where that link takes me! http://www.steelsoldiers.com/showthread.php?p=49

Thanks,must be on my end.

Check that link, takes me to something else!

Yes.

It has been done here a couple of times!

Found it! http://www.steelsoldiers.com/showthread.php?p=646938

Not the stock setting. The fdc unit (where the fuel screw resides) was missing from the lds pump when given to me, I used the fdc from my Ldt pump which had the the fuel screw turned up. upon installing this fdc on the Lds pump i turned the fuel screw down about 12 flats to be on the safe side...

Yes, under full load on the expressway pulling an m146 trailer weighing 10k lbs.

Most deuces are the Same. However, one desirable upgrade would be an air shift transfer case instead of the old sprag transfer case. Most likely this truck does not have lockers.

Wow, that's a lot of play!

Working on that!

Here's Steve getting stuck! 2014 Florida Military Vehicle Rally: http://youtu.be/LrRlGOLRtj4

A bulldozer behind the 211 connected by a big chain might work, but if by chance the truck broke away it would be doing 110 before it reached the bottom! Be ready to bail!

Try installing the fuel shut off lever shaft assembly with the govener rod disconnected, then connect the rod and c clip.

I vote to keep the same dates.