Search results

Those will be some exspensive tires!

Way cool!

Ttt.

Almost time!! I'm sure everyone will be hungry after the parade, I'm going to dinner at the "Jolly Gator" in Geneva this evening to check it out for a possible place to eat lunch after the parade!

Yes sir.

There's a retainer washer with inside fingers That presses over the pin and sets into a recess in the plate.

They work very well and cost around $30.00 at most any truck supply.

A pic of the Teflon plate.

Yep, back around post 260. When i bought the trailer it was missing r side landing gear, i tried to find an original to replace it with but to no avail, so had to find a civi set, they work quite well.

That's awesome and you could pull a support trailer behind as well! I have a Teflon disk on my trailer fifth wheel plate (no grease needed), using the ramps tends to tear it up.

You have rear leveling jacks on your m348? None on mine but I can side level by pulling the pin on the landing gear cross bar, the rear suspension will twist to follow. I would like to find an electric 12v motor conversation that would adapt to the gearbox on the landing gear (the one on my...

Thank you! Yes, it's a leveling gauge, there's one on the front of the gear too. They are inexpensive plastic ones from camping world.

No 4, i had to edit after I thought about it!

Truly a work of art!!

Finished up the latching mechanism for the quick deployment ladder storage compartment! It operates so smooth!

Thanks Bob! This will be #4!

Try paver sand.

Readying the "Taj" for the Georgia Rally! Repainted the insides of the front and rear doors. Working on the latching system for the quick deployment ladder compartment!

I had dim brake lights on my deuce tractor, was only getting 14 v to the connection. It was a bad brake light switch causing the low voltage. Replaced switch, problem solved!

Rescued a stray dog when I was a kid in waldo 48 years ago and named him "waldo"!