Search results

Hey Gamma goat one, I clearly remember being told the same thing at a training class on Goat engines in the mid eighties, I remember an AF FTD instructor lecturing that the real purpose of the supercharger was to assist in exhaust cycle scavenge , *( which apparently was found lacking )...

Pre Post, what an argument. The distance from the intake side of the exducer and the post side is about 1 and a half inches I seriously doubt you will get an appreciable drop in temp, Simple exhaust velocity will STRETCH the heat across the face of the rotor . If you see 50 degrees I would be...

I am not a bobber type, BUT, you did a fantastic JOB WELL DONE SIR

I drive my M 109 A 3 daily, I run a pyrometer, I use 299 degrees as the shut down point, Its not oil temp your looking for, the exducer and the outer turbo housing are different thickness,s and cool at different rates, the goal is to get the Rotor (exducer ) and housing close enough in...

have you looked at the TM 11-2300-475-13 and P-4 its mostly install in the carrier, dated sept87 for an AN/GRC 193-A set up.

If your hangin with Kimmy see if she will fess up the 4 million dollar diamond, I see a TANK in your future !

You guys never cease to amaze me .

Don't be a stranger, let me know if you need anything. Just down the road in the Lisbon area !

Ive found if the gauge is working its reasonable to use it to look at performance. If its in the red your out-put is high, any time ive had high out put it fried the alt any way, if its low(yellow and below, check it with the PSM 6 (multi meter, adj if you can ) make sure your ground is good and...

Congrats !

just an aside, but I did see a photo of the rear frame area of an M 923 XLB a while ago, it had X bracing (bolted and riveted ) at the rear area

Not at all, in fact I installed two cross pieces in the tongue area I scrounged of another frame, I kept the spacing roughly the same , BUT, I welded them in with continuous full joint welds, rater than bolting. I did thought build my mount tabs for the deck similar to the factory and I welded...

been there done that

" Army Radio" out of the UK may still have some, also not sure if they are still in BUSINESS but Jar head used to have parts There is another repair station out there listed on the innerweb, just query RT 524 repair, they do receive units 442 ECT AS WELL, along with alignments , last time I...

Its a quick fab job to mimic the rear cab support on the present cab to match the rear of the new cab, if your lucky you can get a spare one and mod it it, Ive Rockwell tested my 109 frame after reading the blurp on the "special treatment the frame recievied during manufacturing, I have read a...

You Guys are Great! Hope you are there if I break down! Even though I only read the string, it was a success! thank you from New Hampster !

Would only buy it if it came fully fueled and with a load of "W" munitions, needed a repaint anyway

Count me in !

**** , Rusty you shouda told me, (in the water?) lol your right

BUT, after you sell it for twelve thousand with a 12 k loss on your investment, Guys come out of the wood work saying " OH man , wish you had told me, I would have given you twenty grand for that baby! " If you buy one, buy it because you want to , buy it to keep and buy it WHEN you can afford...