Search results

I will try to post up some current goofing off pictures tonight....its been kinda hectic lately.

The rear axle replacement wheel bearings arrived and i have them packed and ready to go. I also got two new inner shim lock rings that were all beat to crap. The spindle nuts were repaired the other day. These will be getting installed tonight. Brake lines have been done but not bled but i...

The only reason you noticed those pics of me stripping metal parts for $$$$$$$$ was you just cameback from NY or otherwise you would not have noticed.

With all the parts hunted down nothing brings this unit into a specific model make and components put into it - take that for a challenge although we know Manufactured it.

I bet you did not know an aligator cannot stick its tongue out nor can a pig look UP into the sky. Thought i would lighten this up a few notches.

I understand and there might be times temporarially to perform a repair like that.....but i am sure you would not leave it like that and correct it. The drill chuck thingy was only a broad fyi....but i bet you have seen many folks that did not know that being a machinest....i see you nodding...

March - angle mini grinder that take many 1/4 shaft tool arrangements - one of them is to use 3M scotchbrite 2in and 3in pads. I use the medium and course in most applications. That is what I used. The collet end spindle nut also is the shaft the end seal engages with. Gotta figure here folks...

I know one thing - those giving advise of what to do and what to spend your money on and what you want - tell them advisers YOUR taking DONATIONS in cash and you will only consider doing it that way - BUT their donation is non returnable and in no way their name becomes part of the title. See...

End of pics - you can see where mutilation to hammer on and off spindle nuts damaged the bearing cages - IF I recall reading this the TM's tell you to beat the h** out of spindle nuts with a hammer and chisel or screwdriver or rock to remove and to put them on - totally forget about wheel...

Easy to figure out what is getting done and is done.

Before I get to work pictures I just have to say this - not saying it will drive me more crazy. It does not matter who did this and when they did it - THEY WERE AN IDIOT plain and simple. I have seen this type of so called "work by a mechanic" than I have seen it done the proper way OR even...

I like that anti-gravity frame. Did the tool come from Acme where Will E Coyote gets his stuff?. Very impressive TWM. Top grade workman ship. The parts look like they rolled right out of the production line.

Won.t wash down. I have it chained to Debs van. YUPPER....next couple weeks ya better not blink because some great stuff is going to be coming at you. There is "detail" work that will need to be done along the way so keep looking close.

Saturday is going to be a busy day - should have the rear all tore down and chase parts and hopefully get a good deal of it from the Master Cylinder to center differential extension rubber line in along with the line to both wheel cylinders - IF I can get the rebuild kits from Napa locally if...

I highly doubt it sits till done hot or cold without a day i do not work on something for it......just ask the mass's here if they think i would let it just sit. Loosing bet.

Dog gone straight it is - gotta be at lease 20 visits in that there heap o stuff. Be sure to order each one and make sure each one fits as I get it also. Playing with the wire harness in the back room with the AC on till I hear Debs van pull up and then it will disappear. Does that look a...