Search results

Ok, I will test those tommorow since I already removed the bell housing to get to the exitor. Thanks again.

A1 diode as in a bad avr board? Where is the main gen diode located?

I temo I removed the diode and tested it. Thats how i got the 10.5 ohms on r16

R16 resistor is showing 10.5 ohms instead of the 3k in the manual. Im going to replace it.

I agree, tested the exitor leads and got a 28.2 reading. Close enough to the 3 ohms.

All my libby parts match exept r16 which i could not find. These are the test results. I think i have en exitor problem.

I cant find R16 in my 805a control box. Can you point me in the right direction please. The manual has no mention when I search for it.

Will check each part. I learned about this mix and match the hard way. I have two 805a, one libby and the other trc. I put the TRC avr on the libby and the avr started smoking. Yikes. 🤪

Hi Guy, I have the same undervoltage problem with my 805a. The voltage drops once I release S1 even after 10 seconds. I have a libby AVR and changed the capacitor for good measure but Im only getting 60VAC on pins 7&8. The hertz show low but when tested its adjustable to 60hz and speeds up the...

Hello, where did you send the avr to be repaired and what was the approx cost?

Its on my Mep-007B 100kw genny.

What battery group and cca should you use on a 007b?

Got her to crank but no fuel to the injectors at all. The fuel just comes right out the return line. I ordered a rebuild kit kt85166 from Ambac. Will report after its done.

Hi and thanks for your help. I was wondering if you could send me a foto of where the start disconnect switch connects. I have included a pic of mine. Many thanks

Thanks. I read about the start disconnect switch in the manual but cant find where its placed on the machine. It looks like its clips somewhere on the crank relay coil. Also, do you know how I can get a spare since its broken.

Im going to check the cable number and report back. Thanks

Howdy. I got a nice mep 002a but it has some issue that maybe you guys can help me figure out. 1: The first three pics are of the fuel injection pump. I have circled silver colored plug that i had to put on since diesel was spilling out when I cranked. The question is wether a plug to bleed the...

It was not easy. I managed to get a guy with a lowboy to deliver it for 1500$. I had to pay the broker another 350$ So they moved it for 1850$ Quotes online were 3k plus. The problem with these units its that they are usually not roadworthy cause the tires are rotten. It would be cheap if they...

I plan to rent it out.