Search results

We have appointments here and I made an appointment and I have put 850 miles on it while I wait. I kept moving my appointment out while govplanet was working on my title

It came with the truck. I haven’t seen but a few with it.

I think the H-1 rails are aluminum. I figured they would gouge from rocks.

If your score the angle with a cutting wheel and then bend it. You will get a nice straight bend. Looks like you did just fine. I don’t have a torch set up but I have miller mig welder. I have thought about making rock rails out of aluminum. I have other stuff to do before I get around to it...

I’m good with runaway. I just want run. Lol I think I got a bad ip and I looked at tm and I can’t find a part number for turbo trucks. I would like to have mine rebuilt but I seen some really bad reviews from the Stanadyne people in Las Vegas

I just sat in on and lined up the holes. I didn’t know it had a special procedure. What would happen if I didn’t do that? Lol not get fuel?

I took the return line off the ip and turned it over and fuel came out. I couldn’t see how much came out but the lid was covered in fuel.

The line that threads into the injector? I opened the one on the rear cylinder on the passenger side. I will open both. Maybe it was a coincidence then on the plug. I had clean fuel and it was full inside the ip when I took the cap off.

Still working on my non runner. Today I replaced the IP cover with the new solenoids. I had a messed up boot on the back connection. I tried to start it and I got nothing. Open up the water separator and cranked it over and zero fuel came out. I was thinking that maybe the check valve was...

I have a plastic cover underneath my dash and I had some insulated mat hanging down on the drivers side. I couldn’t see anything and I’m reaching up there thinking about scorpions and black widows. I taped the washer to the nut to get it started and then tore the tape off. I had the ac on the...

I sent mine back in December also and I think I got back last month. It will have the model right but it will say OH on it under style or something.

I believe Federal has some that lock inside and outside or just outside. They are pretty spendy but cheaper than a door. I like the idea of being able to lock myself in if needed. When I get to the point of installing my doors I will have a set on them

I think they all rattle. I loosened up the clamp on the pipe comes out of the muffler and I got a big pry bar and put it between the muffler and the heat shield and got pretty aggressive and then I tapped on the clamp to put a little pressure pulling away from the heat shield. It doesn’t rattle...

My m1123 was less complicated.

Do you have the guppy model? I have that extended front end and I did see the two on each side.

Today on my m1165 I installed my fording cup and I put new hood stops on. Had a few parts come in that I needed. I was going to Change the cover to my injection pump only to realize that I don’t have a 5 point torx and neither does my neighbor. lol I have the best neighbors. I need to adjust my...

I would rather turn what I got. That rotor is so thick and it’s solid. I don’t know where the eBay rotors are made but probably not here. You can get some really nice brake pads for the money you would save by turning them. I don’t like replacing things and I have been taking stuff in and having...

If you search there is a good thread about Nissan Armada springs and it has some good information Search Armada in threads. It came right up

Really nice looking truck. I wanted to do mine like that but I wanted gloss black. To do it right is really expensive.

I’m looking at this stuff right now. I have my new non runner and it has a few leaks and I don’t want to replace more than I need to.