Search results

download the manual from http://cdn.greenmountaingenerators.com/wp-content/uploads/2012/10/MEP802A-Engine-Parts-Manual-DN2M-TM-9-2815-252-24.pdf

it's a tie between power steering and air conditioning. i have no idea anymore what it's like to NOT have power steering, i put it on all my trucks for the past 18 years. tom

is it pipe thread? in which case the thread seals by interferance fit, and some sealant would be a good idea, or does it have straight thread and a washer to seal. by the way 'sealant' on pipe threads is not really to seal, as much as it is for ease of removal in 20 years.

The solenoid only moves to run when you first crank it. Then it stays there until it is called on to shut it off. The solenoid is controlled bu the electronics that monitor the engine and generator, so the main switch may not be the problem

yes, you would need a controler

knuckles, you are about 60 miles from me, throw it in a truck and come see me, I have 10 units, so plenty of spare parts.

You need to start at the beginning, which sounds like it would be the lube system. drain whatever is in it, make sure it is clean inside, new correct (NOT 2 cycle oil) oil and filter, new fuel and filter. Get engine running before worrying about other things. MUST be grounded or you could be...

does it start and run? if the negatives are tied togeather it has been changed to 12 volt.

since you can get new ones for $50 i don't really see why you would bother with an old one.

no, the fuel 'system' stays full of fuel, especially the injector pumps. the system is self priming with the supply pump running for maybe as much as a minute. what can happen is the plunger can stick in the up position if it has sat for many years.

these are often referred to as gravity fed pumps, they just need fuel flowing by the connection.

for all with fuel delivery problems: This is dependent on the actual design of the pump, but just because the bottom plunger moves, does not always mean the actual plunger is moving. Remove the injection line adapter and under it is the delivery valve, in the center is the plunger part of the...

i believe the 900 is wider so that would be obvious and i think the 800 is the same, so i don't know what it could be.

many 5 tons are the same as the deuce

make a bump key, it will open almost any pin lock

pay for everything with a credit card, call cc company, get refund, buy from someone else.

etn550, we wanted to know if the fuel was being injected or left over from some other event. this proved the injection system was injecting.

are they not the same as the 802?? oil = 51374, fuel = primary 33472, secondary 33348 (wix) as to not starting, you know the pumps are working and the heaters are heating, so about the only other thing is are the nozzels spraying fuel correctly in a mist or just a stream. odd that all would fail...

ok, well it just sounds like it is too cold to start. maybe the heaters are bad. put a hair drier on high in the air filter intake. it is normal for there to be a lot of black smoke at first because they start at max fuel delivery.

crank it with the switch by the filters so the shutoff solenoid is in the off position. is there any smoke now? use the preheater and do the same, any smoke? this will indicate if it is the fuel system or if there is just a lot of fuel or oil in the cylinders.