Search results

Yes will do when I have more pictures and work done... :-) For now I only mounted the throttle switch and do all the electric wiring inside. Need to change vertical exhaust tube from turbo to muffler with a stainless one. Maye there are also mild steel v-band flanges, but I didn't found...

Preparing to install an exhaust brake on a M1078 A0, the throttle switch...

Nice!

Thanks! But how to know what part is what? There is no description, just a s.n.... :-)

Very nice! Christian

Used as our second home... Öland, Sweden this summer Christian

Hello all. Does anyone know the right transmission oil level with cold oil and stopped engine on a M078? I change from normal oil to ATF and now I have the problem that the level is not clear enough for reading with running engine. Right now it's about 1 inch below min. with stopped engine...

Hello all. As promised the Arduino sketch for the CTIS controller. The sketch is complete, but the I/O pin's are set on default. This because depends on the wiring (I made a PCB). The sketch is also able to read / write the default pressures of the 4 terrain modes. You need to write the 4...

If you are changing the tire and the CTIS wheel walve will not close after pressure check or inflating, check the banjo screw if there is some dirt. Happen to me yesterday. If the pressure don't fall under 20 psi between wheel valve and banjo screw the membrane do not close... Christian

Hello all! I have a strange problem with the air brake pressure gauges. Pressure is about 120psi on all 3 tanks, CTIS is working well, but the 2 pressure gauges shows front brake 90 psi, and rear brake 120 psi. Does anyone had a same situation? The 2 pressure transducer are near the left front...

Any news for the lockers? Christian

Mine also, registered in Germany. Italy is a nightmare, but I will retry this winter. Christian

Hello! I now build in total 4 and sold 3. If someone need a complete ECU as descibed before I will sell them for 200$ + shipment. Christian

Hello all. Sorry for the late answer, but due heavy work I did not found the time to answer. After 2000 miles I must admit that the Arduino and CTIS do a great job. It works like a sharm, every 15 minutes checks the pressure and adjust it. No problems after all. More problems with broken...

If you don't hear any solenoid clicking means that the system is not ready. Most probably as Ronmar wrote the wet air tank sensor...

Awesome! That's a good tip! Thank you very much! Do you have a picture also of the other side of the hose? Christian

Thank you! That I think is the best way to solve! Do you remember what kind of attachment they had? Jig or flat?

Happened today, 1000km from home. Frame and rear axle is full of oil, what a nightmare! Now I need to find some hydraulic hose shop to get 2 flexible ones... Loose about 2 liter of oil. Of course on weekend, no one is working... BTW: are the original hoses of aluminium or steel? Christian

Hello NDT. Should be the winch gear case full of oil?

Hello again... Anyone knows what item no. 43 do? Thank you and sorry if I insist... :-) Christian