Search results

Wade I bought them from B&B

pictures also the military bell housing that should let it bolt in where the LDS mounted .

I bought two mack ENDT engines today one is a 673E and not sure about the other. The one engine has a SAE #2 bell housing I was told mack only used SAE#2 clutch on there gas engines or the military trucks .the same engine has a belt driven power steering pump .that I have never seen on a mack .

What I like about this weather front is that is case of a a brake down you have a warm dry peace of card board to lay on .

Yes I replaced them on my m52a2 so my new seals will have a new surface to ride on the old ones had a grove . They act like a wear ring or a speedy sleeve just so the seal won't grove the axle it's self . to remove them put a chisel on it like you are going to cut it but tap it lightly in a...

In California can these trucks be used commercially on road or is it only off road ?

When I first bought my m211 1986 I installed a safety switch on the fuel to turn off the fuel when the oil presser dropped to low so if the engine died it would not keep pumping fuel . and I had this kind of problem because the oil presser on the 302 is not very high when idling and it would...

The right ammo by Hornady. I was given these for the holidays check out there wed site .

That a neat looking RV . any chance it be longs to SS member ?

I yes you should . I turned my m211 in to a tractor I pull a car trailer and can move the larger trailer when I need to . It's easy to park in town when we go to dinner . the bed was just to tall .

North of Farmington NM

27 inches on the back I would leave the front drive line out for now . you don't want any damage done to your transfer case simple pushing and pulling can lead to problems

outside to outside of tow eyelets 35 3/4 inches just under 3 feet

Empty it should weight 5740 pounds on the front

I hate to hear this kind of story . Your not even home and you have been targeted . sounds like a movie . Good luck

With your truck weighting !8,400 empty you may be able to register it for 26,000 or under and not need a class B . depending on your state . I had one of my trucks that weighted 14,000 registered for 16,000 and the GVW was 32,000 .

You are right Suv

I would guess the generator set to far back on the trailer because of the fenders on trailer won't let the duels roll any farther ahead and the weight worked the hitch off of the ball on the truck from the constant up ward pressure ?

You might check across the surface with a straight edge . you might find a high spot or a twist .

Look on the passengers side of the frame just ahead of the shock arm there should be M211 #####