Search results

There is a master list, it is called TM 9-2320-289-34P, part number is 14076847, resistor, fixed wire. Get out your multimeter, connect one lead to the glowplug relay where the resistor attaches, connect the other lead to ground, set the meter to dc volts, it should read approx 24 volts, turn...

Ground anchors

Probably a generator trailer, reel would most likely be used for a power cord.

No cables connect to the back of the radio, it connects through the mount. You could put a remote speaker on the mounting plate, but I believe the original purpose of the plate was for NBC equipment.

The first picture is a M101A3?(M116A3 chassis), designed for use by hummers, notice the wheel sticking out, that offset is designed for a hummer wheel, usually when modified the fenders are flared but I don't see that on this one, they used these trailers untill a dedicated hummer trailer was...

I tried to rotate and save the pictures but for some reason I couldn't get it to work. When the radio gear is running it sounds like a shop vac inside, you can't hear any heaters, or yourself think! That clock was NOS, it was one of my prized finds. It runs off a 9v battery which is used to...

Here are a few pictures of my AN/GRC-142B teletype shelter restoration, fully operational, just need to find the fuel heater.

Narrowed the search down a bit anyway, found the passenger compartment bottle bracket thanks to Maddawg, still need the brackets/mounts circled in red and added a picture of the welder bracket by itself. Carnac is hot on the trail and any other help is appreciated. I have additional detailed...

Anyone?

Check vacuum directly at the pump, should be 24-25 inches at idle.

I think the $150 minimum bid is for EUC items which require additional man hours to process thus the extra cost.

When I received my AS-1729 one of the hooks was loose in the bag, I suspect this is a common problem. PM sent.

Interesting unit, perhaps is was a prototype/experimental project. Should make for a great camper project, plenty of material to work with.

Poor/dirty connection at either end of the cable. Make sure all the battery connections are clean/tight and check to make sure the starter is in good working order, not dragging and pulling extra amps.

:popcorn:

Valve, vacuum regulator pn 14057219 TM 9-2320-289-34P page 14-1

Did a SS member here win the M1031 yesterday? If so please send me a PM, thanks.

If you have first and reverse then there is a good chance the trans is ok. Make sure you have 24-25 inches of vacuume at the pump, next check the line from the pump to the switch on the IP, check the position of the IP mounted switch, start with it fully counter clockwise, this will give it...

Yes they do go bad, about $95 for a new one. If you rotate it back toward the firewall it will shift faster, rotate it toward the front and it will shift slower. You can test it but you need an accurate vacuume gage. Also test the vacuume at the pump, you should have 24-25 inches at idle.

The only thing different is that the ground stud is isolated from the case by an insulating bushing. If they can't figure that out, bail!