Search results

I have a ladder, have to dig it out for a picture. I'll do that a little later. Wife calling, dinner or something.

Nice looking truck, Sheet metal looks straight. Keep up with the pics.

As mentioned, if you chance you gearing you'll go faster. Try stopping all that weight is why the brake upgrade is a good thing.

Looks like most of the M is in the cargo box. Looks like a great project!

Weld in the cab corners? The pictures I saw the corners look pretty good. I wish mine looked that good. Keep up the good work and the photos coming.

I hope I could help. When I took my bed off I did it in pieces. I think there are six bolts that hold the bed in place. Two at the tail gate (in the bed look for two bumps about 18 -20 out from the center) In the middle just in front of the rear axle again two bumps. The two up by the cab, I...

Great find, take pictures and ask questions. Find an extra seat let me know.

AS noted the blank is where the slave receptacle is located. The broken piece you mentioned is or was on the E-bay. Others may have them , Midwest Military, A B Linn, and in your area Adirordack Parts.

Welcome to the site. Hope I could help with any question. I took what was left of the cardboard and clips from my M37, Not much left to work with, Tried to make a pattern, not much luck. some day I'll get it back in place.

Are you going to fab a harness?

popz76 Not knowing all the if ands or butts with your case, lets say the power comes from a circuit breaker then to your gauge then to the sending unit. The gauge should be grounded and the sending unit should be grounded. The vehicle frame is the neutral wire. This makes a complete circuit...

First is your M 12v or 24v? Second , check ground between the fuel tank and the frame with an ohm meter, a zero reading should be obtained. The correct fuel sending unit for a M37 should read between 0 and 40 ohms. If it's higher replace it. The ohm meter should indicate a higher reading as the...

Are you going to replace the harness with the same type connectors? What year is your M? I replaced all wiring. From the harness to the lights you'll need to purchase or make wire tails for each head light ETC. If you elect to fab yourself, keep note how long each tail is. If you could locate a...

I looked for my TM on the heaters. Could not locate it. As mentioned One heater mounts on the passenger side and uses the keyhole knockout. I believe this one is the unit that the passenger side running board is moved back about 3 to 4 in, for heater hose to pass by. Look at the running board...

OOPS I should of said "" If you know it was cut"" I owned several MUTTS only one was cut, The others were lucky. I still have a 1969 M151A1 uncut. Again the one MUTT that was cut the previous owner left the wiring harness a mess (right where the torch cut it). Sorry If I didn't make myself...

I have a 54 Canadian with the hard top. this has the rectangle type window. It must be from the factory, It doesn't have any loops for the canvas top to tie to. My 51 M37 is a soft top it's the one I use for my avatar.

With all said about where to look for the re-weld, If it is a re-weld look for the wiring harness at the cut area. What shape is it in? You know it had to be cut, but did the previous owner do a good repair job or a Buba job? If Buba had something to do with it, your job to make it right just...

Looks like he could of saved a lot of time and money and picked up a M416.

Don't forget to post a few pictures of your project. We all like to see some forward progress. By the way nice looking truck!!

I was a little short in the seat area. I used a few throw rugs until I could locate a seat.