Search results

any idea on the cost?

Mine looks just like kenny's. I borrowed his idea

haha just bought a locker. I havnt picked it up yet. the seller bought it for some rockcrushers with 4:10 gearset. he says it will work with the 4.56's in the 1008. he has two rockcrusher housings for sale if anyone is interested

thanks

I set up a 11gal tank with a 1/2 t on it and a 1/2 hose running to the gun, then I put a male quick connect on the hole the little hose comes out of so I can fill it with the compressor at home or the glad hand. works good. I can even remove 4 front spring u-bolt nuts with one tank of air...

I think they are a different thickness than the upper brackets

RE: Another thing you can do with A/W crane mounted on a m81 to make it rotate I think you just have to take the stops off. Is that correct????

I used my 1/2 ton suburban and pintle to bring my 105 home. I would like to put in a order for a ball to pintle adapter so i can pull my car hauler with my MV's

i will check mine and see

I decided to sell if anyone is interested

I have one for sale. I have not put it in the classifieds yet, but I decided to sell it for sure. PM me for info

it looks like the rotator motor and crane winch motor are the same

Re: RE: Re: RE: Re: Front winch install progress..slow, but I did not loosen the collar. maybe that is why it wouldnt fit. thanks for the tip.

Re: RE: To Deuce or NOT I have both and I agree. for your aplication a deuce will work great. and if you get it stuck it will be easier to get out than a 5ton. plus smaller for the trails you may hit on recovery jobs.

I need one for the hydro spin motor where the manual square nut comes out. let me know what you find out

I just went through this and had to heat up the center section of the pin. however with the maul you may have mushroomed the bottom of the pin. I did that to another one and had to cut the mushroom part off

I think it is a M246. 5ton truck-tractor -wrecker with the gas motor in it looking for a wiring diagram

it was just a little bit, spent 10minutes turning it every which way and it wouldn't fit.

I made the mistake of bolting up the winch before the driveshaft and had to loosen it up to install the shaft. it doesnt take long to install, I lifted it up there and set it in place as my wife put a 2x4 under the top plate as a lever and adjusted it up and down so I could get the bolts lined...

I have a bid to haul it the 500 mi. for $2800. $5+/mile is steep