Search results

I'm on the trail, shakin' hands and kissin' babies!

Agreed 100%, I'm not groundhog dayin' a 6.2 motor. I wish I was closer -- I'd buy all 3 from you! aua

Apparently I mounted my antenna twice Saturday--and installed my led taillights today.

Don't feel bad, my soon to be 998 needs a new motor also. Mine has only had the injectors, alternator, and belts removed. Someone also helped themselves to the headlight and ignition switch.

Goal achieved! Run or walk, you ended up where you needed to be.

Always a pain when they wont turn-- like Doghead said convertor and flexplate or the trans. attached. Get your catch pans ready.

Dog tags from fallen soldiers

I will be there!

Patina is another way of saying I really need to paint my vehicle, but I didn't do it yet!

rear axle I would start by checking the dog bone mounts. These are a weak link on the truck and can have similar results as to what you have pictured. Usually they pop off, but you may have one that the rubber bushing is worn out and letting the axle shift. With a constant clunking sound it...

I am going to try and make it, depends on work.

I gutted my ctis, brass plugged hub, and replaced seal with regular drum seal and have no problems. No heat issues and everything seems to be lubed/oiled properly with no leaks to report. 74m hows my pink a/c bracket? It's hawt out and your sister wont ride in my truck till I get my a/c installed!

We ground down the center a little and welded some big, thick washers purchased at fastenall-- east fix and haven't popped one off since--we did all of them. These are the weak link on the rear of these trucks!

My yearbook picture!

I checked it out this afternoon and I have power after bulkhead connector, but not at headlight. So-- I will just coverlay a new wire over to the headlight. I'm not pulling all that harness apart! Thanks Andy and Swamp donkey for the help.

Gotcha

Thanks S.D. I will check that wiring tomorrow-- stay tuned!

I know my OCD will flare up if I do that, but if it can be fixed relatively easy, I'll try to troubleshoot it first--or just shoot it!

I'm putting the finishing touches on the 923 after painting. Had a little free time today, so I figured I would install my headlights. Easy enough-- well not really. So, this is what we are working with. 7 inch glass lenses w/ hella 24v bulbs. Drivers side works fine, passenger side has no low...

You should be able to either hear or feel the condenser fans coming on, if not, that is a problem to start with. There should be a switch at or near the drier that you should be able to jump to see if fans power up. The drier on some systems will be hot to the touch-- it seems like it is usually...