Search results

What are the "Air lines / Vent lines" that go to one side and out the other side of the Distributor for? When I bought the truck most were closed off with bolts stuck in them. Where can I find a diagram of the venting system? Thanks, Nate

I have a All Stock M715, I just on the farm. It has a brand new distributor, wires and plugs, fuel pump and carburetor. I need it to sit there and idle at times. After about 5-10 minuets of idling, it cuts out and will not start. After about 20 minuets she fires right up like everything...

Electrical Issue No Power going to the Coil, Batteries all charged, and turns over just fine. Any Ideas where to start looking?

What weight Transmission and Transfercase oil dose the M715 use? Thanks, Nate

Replaced the Distributor "Which worked" With a newly rebuilt one. Now im not getting any spark. 24.7 Volts are going to the coil at its + side. How do i check and see if the right amount of power is leaving the coil? Also, then put old Distributor back in , and now im now getting any...

On the back of the Carb next to the block, Is a small copper pipe that wraps around the engine, What is it? "The light's not good enough to see out there right now, and the flashlight just took a dump on me." Can it be disconnected and blocked Along with the old im guessing pipe that goe's...

Carb work Mechanic said too much gas going into the card, so he readjusted the float. Now slow acceleration and back fires when turned off.

Rubber Gasket Anybody know where I can get ahold of the rubber gasket in-between the carb and the air filter? Thanks’ Nate

What is the Rubber hose, about 1 ½” wide that is on the right side of the engine next to the oil filter” if your in front of it” that goes from the bottom of the block up to the air filter? It has some kind of connection tube on it about ¼ ” wide that connects to a small pipe that looks like it...

Dose anyone know what the electronic ignition pickup coil is supposed to Ohm out at? My mechanic asked me.

Anybody know the Kit # for the M715 Petronix electronic ignition?

Anybody know what size the O-Ring is in the Carburetor?

M715 backfiring New plugs, wires, coil, distributor cap, Electronic ignition and fuel filter. Runs good for a minuet then starts to bog down and then will back fire. Any ideas

Anyone know a cross-reference for the M715 Distributor cap?

Where can I find a reasonably priced M715 coil? Thanks Nate

What’s the secret to get the started off Looks like the back of the started is pushed against the engine block?

New WalBro 6000 Fuel Pump put on the M715. In the bottom of it, the little anti siphon ball keeps getting stuck shut after 5 miles of driving. Have to stop and push it in and then go for another 5 mile. Can I take it out? What is the PSI of the WalBro 6000 Fuel Pump? What is the PSI for the...

M715 Water pump How do you get the pulley off the old water pump, and put it on the new one, without screwing it up?

Anybody out there know what Thermostat I can go buy from an auto parts store? Thanks, Nate

Put a new needle valve in, and it keeps sticking shut, running 4-½ psi fuel pressures. Its not the float closing it, its just sticking shut. Any ideas on freeing it up? Thanks, Nate :?: