Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I have never seen a deuce drop side bed up close and in person. I am a proficient welder and fabricator and wondered if I could some hinges on and use existing drop side bedsides to make the conversion. I use my truck for hay hauling so the sides are nice since I bale small squares, but I would...
Hello all, I was doing some searching on here and read a bit about some of the newer deuces having brakes a bit different than mine. I have a 71 with the air assist brakes and I want to put in a dual circuit master if possible to gain some sort of a safety measure and to keep the air system. I...
Hello all, I twisted a rear drive shaft coming off the Tcase to the first drive and sourced a replacement from a parts dealer. I put it in and it went well but there was only about a half inch in between the flanges with the shaft fully compressed. I know there is not an insane amount of travel...
The Deuce I am getting has a hard top and a heater, however from what I read the heater in these trucks leaves a lot to be desired and I live in MI where it gets a little nippy in the winter. my Idea was to run the fresh air inlet to the heater into the cab so instead of heating cold outside air...
I searched high and low and I cannot find anything on the sort. I really want at least an 11.00 tire so I can pick up some top end speed but I cannot seem to find a tire that will not cost my first born or less. The thought crossed my mind to run 11 NDT tires but cut the center rib every so...
Pardon me but I tried searching and I'm not getting much for details or results. I want to put in an EGT gauge to protect my motor but I cannot find much info on it. Yes yes I know the details on how to install it and where but what about the fact that they are all supposed to be 12V? how are...
Hello all, I am still getting used to this site and all the info on here and searching so I hope I am not beating a dead horse. My question is do non winch trucks still have the pto box? If they do has anyone hooked up a hydraulic pump to it for winches and other hydraulic accesories? The truck...