Search results

I bought one a few years ago at NAPA

Autozone sells a aftermarket with updated design that is brand new unit. I found it works much better than Delco ones.

Are you sure its leaking at the drain? I just had to replace my housing with a spin on unit as the original was leaking (Bad) from the sensor wire on the back.

WOW , youre worried about 4 drops of oil ? I wish mine was that clean.

Youtube videos will show you just how to change it. Type in Chevy hydraboost repair

Yea mine started leaking and I took mine out. Brakes work better now and have never had the rear lockup.

Every thing I found at parts stores were too short. I believe they were for later model trucks, but said they were for 1984 and up. I just cut the pump end off both cables and used a cable clamp to connect the ends back on at the correct length. Works perfect.

You must not be getting at the right angle.

I bought one of the (cheap) gear reduction starters for my 1008 6 years ago. Still working great . Truck used everyday.

I put in a new civilian windshield with the built in antenna, my radio works fine,

Both alts should put out about the same voltage. 14.5 plus 14.5 is 29 volts. System is not over charging.

You likely have reversed the vacuum lines at the valve.

If your wipers are slow it may be that the alternators are not putting out 14 volts each. Is your volt gauge pointing at the [ G } on the gauge?

Death wobble is a horizontal(left to right) movement of the tires , not vertical.

You need the cooling system serviced. Themostat,fan, radiator or similar system is not working properly.

I had the wobble on mine, but would only happen during braking. I had a slightly warped rotor. I did a brake job on it and the death wobble is now gone.

The kick panel vents are notorius for leaking. The seal on the back of the plastic vent is all that keeps the water out. If these were ever taken off ,they are really tuff to get re-sealed. Take a garden hose to the outside and see if water is coming in at the vent.

Possibly the suction tube in trans pan not installed correctly. I had similar trouble with mine after sitting for a few days. Mine also had a rebuilt trans and the pickup tube was not on right allowing trans to suck air.

I disagree. Why is it that only 4 wheel drive trucks have the stabilizer on them, and not 2 wheel trucks and cars?

Before you spend alot of time and money on other stuff. Replace the steering stabilizer. Even with all brand new front end parts, if the stabilizer is bad they will get the death wobble. Very common on all straight axle trucks. Especially ones with the King pin Dana 60.