Search results

Please enter me!

Everything worked properly when I parked it. I purchased it back in 08' and have had no electrical issues with it at all. I replaced the stalk and flasher with new replacement parts. I may have to look harder at my repair and other parts of the harness for damage. I will give the long jumper a...

What TM do I need to check the turn signal circuits? I replaced the flasher and the turn signal switch, it only worked for a minute and I am back at square one.

Thanks for the info.

I recently pulled my dump out if its slumber. I was going over items like tires, fluids and lights. The headlights and taillights are fine. I had no turn signals or hazards. I assume a raccoon chewed the wires to the signals judging by the surprise in the battery box. I repaired the wires, the...

Thank you all for the information. It was the vr board. Up and running like a top. I ordered a vr board from Jim at Lakeland services. Shipped out fast, no complaints.

I will look into this and get back. Thank you for the information!

Thus spring I had a power outage and fired up the Mep 003 . I have had this unit since 09' I start it and run a load or no load test on occasion. I had a voltage spike to about 190v sending a few power strips to the smoke god. The voltage output adjustment has no affect on the voltage. I did...

Thanks! That's exactly what i was looking for.

I can't seem to open the link.

Yes the sleeve and pin that controls the fuel collar.

Hello all , I have an issue with the multifuel fuel pin location. I have an lds2 that I saved for my dump truck that I won't be needing. I have not tried to start it in years. Long story short, the fuel pin was sticking holding it in the off position. I tried cleaning it externally but no luck...

What ever became of this project?

Uh, I was thinking the same thing........ Thanks for the TM I will dive into it tonight. Also I prefer Log Cabin,

Which TM do I need? There is a vent on the bottom of this unit about the size if your thumb that faces down. About 8" in diameter round,has alot of air lines and a wire harness with about 6-8 wires pluged in the side. I can't get a pic until I go back after the Holidays.

Our local Village has a few new toys. One of them is a 929? Dump. I have looked through 900+ pages of the wrong Tm and checked a few threads,no love. The issue is the truck won't build air. It is leaking air from a pancake looking thing under the truck that has a wire harness connected to it...

Update? I would like to see your progress. I may attempt a 1990 1/2 ton Dodge 4x4 swap. just need to locate a powerplant and acc.

Thank You Sir!

Our local DPW picked up a 917? Dump. I stopped by to check them out. they told me they were having trouble getting the pto to engage. What is the proper procedure? Thanks,

Great to see that your back in business!