Search results

Thanks for your comment. I should have mentioned that the entire window mechanism was cleaned and lubricated. I also used paint reformer on some parts showing rust. The window moves easily. It is not under any tension. The ratchet is essentially a replacement handle. Sorry for the confusion...

It's taken a few months to finally get the crank fixed and report back to you. I offer the following to generate ideas. It's not an easy fix but it certainly works well. Based on the comments here in the forum, I took your advice and looked at a non-LMC solution. Here is what I and two...

Can someone please recommend the amp capacity for the momentary (push-button) switch? I've seen switches ranging from 4 amps ($4) to 35 amps ($20) from this vendor http://www.texasindustrialelectric.com/switches.asp (middle of page) Many thanks!

Suggestions most helpful! Thank you guys. Both posts have helped me a lot. We were able to crank the window up using a metal rod to engage the regulator and then use the crank to raise the window. It turns out the clutch and handle failed. I am away for a few days, but when I return I will...

My crank just died and I found this post very helpful. I do have a question, I was hoping someone can help me with... My rear window is in the down position with the hand crank not engaging the regulator. This means I can't move the window up to get to the regulator, and then to the hand crank...

Has anyone considered the possibility of replacing the 1009 front seats with a bench seat? In my case, I've removed the back seat and would like to accomodate a third passenger up front if possible. Any thoughts on this? MANY THANKS!!

Has anyone considered the possibility of replacing the 1009 front seats with a bench seat? In my case, I've removed the back seat and would like to accomodate a third passenger up front if possible. Any thoughts on this? MANY THANKS!!

Thanks!!!

Hi Guys, Many thanks for such an informative site. I've been lurking for about a year, grateful for your knowledge and expertise. It has been a source of inspiration and advise! I will be posting pictures. I am not a mechanic, so please bear with me on what is likely a very basic question. I...