Search results

Been working on the ether switch today, here is what I have done: Checked if I had power to the switch in the cab no, so went to TM9-2320-272-23-1 and found the ether starting system operation. I have power to 5A through the CB and to 27 I could not find 5C so I disconnected 498B from the...

I did not have to fill out an EUC when I bought the M923A2 so can it be sold to someone north of the border. I did some searching but I could not find anything recent on the topic within the last 3 years or so.:-?

I have been searching through old posts and have come up with a few answers that might be right. Here is my situation Gen 1 light comes on when I turn the key on and after started it dims a little, when I am driving and the rpms are higher it dims to the point you cant see it in the day...

Just picked up my new to me A2 yesterday,(this thing is going to be fun, a few neighbors almost ran off the road looking at it) I hauled it home since it was a 200mi drive. It seems to be in pretty good shape with just a few problems. First the compressor seems to cycle a lot, it goes up to...

Could anyone give me the measurement from the front of the front tire to the center of the rear axle, I have measurement from axle to axle I just need to know what the tire adds to the distance thanks for the help .

I won me a M923A2 last week and I am thinking about hauling it home insead of driving it. The height of my step deck is about 28" at the step to the deck. My question is what is the height of the bottom of the front bumper to the ground. Thanks

Anyone around that area willing to look at a couple of 5tons, if so PM me I'll throw in some $$ for your time. Thanks

Anyone around that area willing to look at a couple of 5tons, if so PM me I'll throw in some $$ for your time. Thanks

It is a 1990 BMY with 28000miles on it and 900+ hrs, starts and drives what do you think will be issues with it with that many miles which is not much, some I have seen only have half that but they are not close enough for me to get. From the vid it looks like it is in decent shape thanks for...

The more I read it seems that you dont need a lift kit to fit 34" skinny tires or even 35". I was going to lift 4" but if I dont have to then why spend the money right now. I am now looking at a leveling kit to raise the front and fit LTB 34/10.50/16. I just dont want to order some and get the...

I just got a m1008 a few weeks ago and have been fixing the typical things charging and vacume lines. When I get all those issues fixed I am looking to lift it 4"-6" . What is the best complete lift for these heavy duty trucks I want to go with springs and not blocks in the back? Looking to run...

I have done some searching and can not find the answer ( I'm sure it is out there). I have power to the dash light for the gen 2 but the bulb doesnt light up. I swiched bulbs to one I know is working. When I put the volt meter in where the bulb goes gen 2 reads 24.2v and gen 1 reads 12v, first...

I just picked up my 1st 83 CUCV pickup and I have a few questions. When I turn the key on the gen 2 light comes on but the gen 1 light does not. When I start it the gen 2 light stays on, still no gen 1 light. When I rev the engine the gen 2 light sometimes flickers. Thank you for the help.