Search results

Has anyone converted an M101A1 trailer to accept CUCV Chevy 6 lug rims? If so, how was it done?

I had 7 lifters that were hard to remove from the block, I got 4 out, 3 are still in there. The 4 I removed have some mushrooming around the bottom by the rollers. Thats why their hard to pull out. I am replacing them all, does anyon have any ideas on how I might get these out? I already...

Well, here it is. As soon as I get my motor back together in my M1028, I am going to start on the conversion to a camper. Still looking for a good price on solar panels.

Has anyone tried to replace the cam without pulling the heads. After I pulled the rods I noticed I can use a magnet to pull the lifters out about a half inch. I thought about using 16 magnets to pull up the lifters all at once, and slide the cam out and the new one in. Any thoughts?

Hope someone can help with this issue. I put an electric fuel pump on my 84 M1028. I can't get the system to bleed the air. I have fuel at the inlet to my fuel filter, and fuel exits heading to the IP. This entire fuel system has been rebuilt (IP, Injectors, fuel lines, dropped and cleaned...

Does anyone have a source for a rebuild kit for the 6.2 fuel injectors. I did a search and only came up with rebuilt injectors.

Does anyone know of a source for the Vacuum Regulator Valve for the 6.2?

I am experiencing a lack of power under load which I explained in an earlier post. Due to process of elimination my IP needs to be rebuilt. Can I advance the timing to get more power out of her till I can get the IP rebuilt?

I hope someone can help me. Here’s the story. I have an 84 M1028 with 8700 original miles. I was towing an empty M105 1½ ton trailer up and down some hilly terrain. I lost power going up a hill and started to blow a lot of white smoke. The truck stalled and I couldn’t get it to start for...

Here are some pictures of my M1028 with shelter that I turned into a surveillance truck. I still have the Toughbook and communications to install. I have two weeks off for Christmas, so I plan to finish installing the trucks AC. I just have the under hood stuff to finish, and the head liner with...

I am trying to figure out what voltage these receptical require. I know the far one on the right is the 220 output to the 220 input on the front mounted AC unit. I'm tring to figure out what the others are for. I need to figure out which one I can set up to connect to my generator. Any help...

I'm looking to finish up the restoration of the interior of my M1028. I was wondering if anyone has a source for the Blackout lights Decal, and the 4x4 Decal for the sun visor. Any help would be greatly appreciated.

Last night I disconnected the batteries in preparation to do the Doghead starter relay mod today when I got home from work. However, my son reconnected them to change light bulbs and didn’t disconnect the batteries when he was done. Of course I didn’t check them again. I cut all the wires to...