Search results

Does anyone have a source or part number for the glow plugs? thanks!

I have the 802 that when load tested keeps up just fine until at about 70 of capacity, then it bogs down. Anyone have any ideas, pull the injectors and pump maybe to have them tested, other thoughts?

I picked up an 802a and have 60 hz but only about 20 volts output. It will make 120 volts if the master switch is held in the start position, but drops back down to 20 volts in the run position. The genset did not have the quad winding fuse modification, but does now. The some of the diodes in...

I have a leak at one of the fuel injectors (not the pump), the lister parts diagram shows a washer which I assume needs replaced Does anyone have experience with these? Anything special to be aware of if i remove the one leaking injectors to replace the washer if that is the problem? Thanks.

Ok, I purchased an MEP-802a from GL. It had clean fuel, filters and looks really nice. I did all the normal pre-start maintenance, cleaned the fuel tank, new filters, put in new batteries, yada yada.., . The issue is I don't have any 24V power to anything, no fuel pump, no power to the panel or...

There is a previous post that says size 51R batteries fit. Another poster said buy the cheapest Walmart batteries, that was wrong! The cheapest Walmart batteries were size 26 and they do not fit. So I am back to the store to exchange the size 26 for the correct size 51. They cost an extra $40...

I just got a MEP-802A through GL, it is a nice unit and was turned in as excess Nation Guard inventory. I am still going through it but it turns over easily, fuel tank and filters are clean but will be replaced anyway. The issue is the gen head resilient mounts are shot. They are the puck style...