Search results

Is the ground wire from the starter solonoid to the starter in tact and tight,

Are the gauges working on the panel?

I love that step you installed. Here are some pics of hitches we made/fabricated for the 931 and 923. Side we made and then we used a reese 5th wheel hitch which we fabricated to make it work. The lower receiver was purchased and fabricated as well. I originally got the idea from bigboy44.

Almost done

Sorry, I bought a 923 and a 931 1990 and 1991 so the 813 is on the back burner. We will wait till it get a little warmer outside to get it done.

Thank you Carnac!!! I will donate!!! Do you spend a lot of time at the Butte? I'm there a lot during the summer.

I have two trucks I purchased over the last few months. Please provide any information available. I will donate. a. Serial Number (VIN number) ------3109059 b. Registration Number ----- c. NSN without dashes -----2320012300302 d. Where you bought it -Santa Fe NM GL e. Bumper numbers if you can...

?????

Thank you all...I will let you know.

Will not fit without at least an 11 inch drop from the bottom of the frame. Ugh!!

Yes it will. It is less that 12 inches from the top of the frame to the bottom on the pintle hitch. This hitch mounts on the bottom of the frame. I will probably build a hitch but any of these hitches would be fine.

Curt 15605, 15400, 15800 wI'll all fit a 923..they are made for a 34 inch frame. The 15400 has a drip of 6 5/16 from the top to the top of the receiver.

Was that Reds truck?

34 inches..

Yea the 5ton has a sprag. I'll look at that..

No its not out of a turn and no it doesn't stop once it starts but there is not a set time frame between the pops. Sometinew is is every 3 or seconds sometimes a minute.

It is happening when driving straight. The whole truck shakes when it pops.