Search results

Mine is leaking at the IP where the lines all come out separately for each cylinder. The "insert" is rubber and is just not making a good seal.

1985 WHite multi 465 just noticed a leaking line going to the first cylinder. leaking near the line and not around the threads at the IP. Ive tried tightening the nut and it wasn't loose. Any ideas on an easy fix? Thanks

OKay, I'll take your word on it :-D as I don't know anything about a secondary seal...

Why? Why is that? cavitation of the fluid? WHat if I'm using DOT3/4? Thanks?

Yup. gasser here too \ And this would also be a M139 gasser... that was converted at some point to multifuel...

This answer makes sense... I call it a bridge truck because it has the 10 foot or so wide bed with the lockable side panels on a flat bed... and the plate on the front driver side of the bed says Bridge Body or something like that...

HA! You think you're funny, but that's not what it is. The Flux Capacitor Actuator on my deuce looks nothing like this thingamabob... haha Hey, Are you really a doctor or just play one on TV?

1953 5 ton bridge truck body. There's a lever opposite the flasher lever, on the right side of the upper steering column. There's air lines to it and it says not to use for parking brake. It is currently froze and won't move, or else I'd actuate it... Is this the front axle...

Is it Broke??? I recently traded for a 5 ton Bridge truck converted with a dump bed. The power steering reservoir was removed to replace IP... since then it has been started some and Power steering pump may have been run without sufficient fluid... Now in process of refilling PS system and...

Why not just measure between two fixed points on the front of the tire tread and adjust tie rod to equal the same measurement for the backside of the tire tread. WIth tires that big your radius of measurement(which will determine accuracy) is 24 inches or so... and that should be good enough.

parts house A good parts guy would be able to match them to a spicer-type ubolt for certain older vehicles as stated above...

parts house A good parts guy would be able to match them to a spicer-type ubolt for certain older vehicles as stated above...

I am they as well! Actually 10K for two axles would be cheap. Them crazy offroaders have a different goal in mind. For offroaders the object is usually to push the vehicle to the extreme and generally stock equipment just won't cut the mustard... But it's all just hobbies and I do both...

Calling Offroadfabworks!!!! What's the status on the "kit" that was being tossed around last spring????? Inquiring minds wanna know!

Price it How much for either the bed or the whole truck??? My neighbor has been looking for dump truck...

classified ad forum Hey, I've been looking for one of those 24-12v inverters. how much shipped to 72601?

1600 rpm Can you get more than 1600 rpms when shifting through the gears accelerating? (scratching head)

solution? I say trade houses and get some acreage so you can park #2 and 3 and 4 and ..... Seriously, it sounds like you're talking hard top, but you might look into a soft top... Good Luck

same motor? Would that be the same motor that's on a deuce heater which is installed on the fender??? If so I'll see the Napa man!!! Anybody know? Thanks in advance.

local parts store here sells heater hose fittings that have 3/4 or 1/2" NPT threads. I will place a valve in line for summer shut-off valve. But you're the all-knowing Carnac, so you really know this already, right...