Search results

IN

So you replaced all the rivets across the center raised section of the hood with bolts to attach the rubber strip material? Also looks like you made your own steel backer strips. Nice work.

Thanks for the input guys. If I decide to go with the bolt on brackets I will PM you 86humv. Appreciate everyone's input on this.

Thanks for the feedback guys. Kascar has a set of weld on brackets for the roof mounts, so I was thinking of taking that route. I believe the alloy used in the humvee is 6000 series, but I need to confirm that before I can weld. I see NOS soft top windshield frames listed for very reasonable...

Hello, Does anyone know what the structural differences are between the soft top and hard top versions of the front windshield frame besides the corner brackets that accept the roof mounts? I know the defroster vents are different between the two and the hard top frame has threaded holes for...

Hello, I am trying to source both halves of an electrical connector that is used in a few locations on the 6.5L engine harness. This connector is used in the interface to the tachometer sending unit and also on the crank sensor at the front of the engine on the drivers side. It is a 2...

Thanks NDT, DREDnot, and Action for your feedback. After doing some research using the information you provided I was able to find some pictures of the engine without the transmission installed that shows the drain pipe. Now I see that my 1025A2 is actually set up with the correct valley...

Hello forum members, I started servicing the cooling system on a M1025A2 equipped with a NA 6.5L that was purchased this summer and ran into an issue with coolant slowly leaking from a small hole in the driver side rear of the engine block just above the oil filter lines. This hole is between...

Hi Tobys, I appreciate your generous offer to help me with the pieces you removed. Most of the damage to my front panel is on the top rail. One of the boxed sections that holds the brackets for the stabilizer legs is crushed in a bit as well. I finally got some information out of Silver...

Thanks to everyone who responded with helpful suggestions. Does anyone know where I can find the correct tailgate pin and wire rope retainer? I pulled the following info from the maintenance manual. Tailgate Pin: PN: 98320A625 Description: PIN,QUICK,RELEASE (Note: The manual does not have...

Thanks for the input Buffalobwana. I will post some pictures when I return from traveling, but in the mean time I have a few questions. You mention welding the body panels as an option, but I was under the impression that the trailer body is made from the same type of aluminum as the Humvee...

Thanks Shark Bait. I left a message at Schutt and waiting for them to get back to me. Would be great if these part were available as surplus, but so far I have not been able to find any.

Hello forum members. I have been reading the information on this forum for some time and it is always very helpful. I purchased my first Humvee (M988 A1) last year and added a second one to the stable a month ago (M1045 A2). I recently picked up an M1102 trailer that is in great shape except...

Hello forum members. I have been reading the information on this forum for some time and it is always very helpful. I purchased first Humvee (M988 A1) last year and added a second one to the stable a month ago (M1045 A2). I recently picked up an M1102 trailer that is in great shape except for...