Search results

Update: Drove the 1.5 hours to have another go at her. The pump had been removed and soaked to try to free it up. We drilled the rivets and removed the bottom cover. the impeller turned freely. Placed the bearing in the center of the magnetic disk and placed both halves together. hooked it up at...

Ok, the story. Saw this one on marketplace. Short story, gentleman had it for a while, bought a winch for it, put the correct bumper and spacers for it, after a drive he parked it and the starter would not run. He and his brother tried to replace the starter and had issues that spooked them, so...

By what I can make out from the above drawing, it looks like you have two fuses to check. F3 and F6 appear to be associated with the stop solenoid. The stop solenoid has two coils in it. Can't tell if machine needs one or both energized to stay running. Good luck!

I have the knowledge to install it with 40+ years working in a power plant. But I have a good friend who has the proper license that I am gonna pay to do it. It requires pulling the meter and having the utility present.

i have a similar setup problem. Power comes into a transformer in the yard. Right beside the transformer is the distribution panel. It contains two 200 amp breaker supplies. One goes to the house and the other goes to my shop. One problem with this is my well pump is fed from my shop. I looked...

Thanx everyone. I got the barb to hose to pan on floor thing, Mostly I was looking for a way to get oil filter off without spilling so much oil. Real mess. This last drain (a few days ago) I tried an old trick. I punched a hole in the top (as seen from outside of enclosure) of filter then...

So what's the secret. I have changed the oil in my MEP-803 several times and changing the oil filter is very messy. I tried just spinning it off, I've tried popping a hole in the top and bottom of the end of filter to drain it but I always end up with a large spill in the enclosure. I don't...

Where you at? I'm close to Vidalia. I have a load bank that loads my MEP-803 to 97%. Personally I like the 1040s. Then again I work on two generators that output 920MWs each.