Search results

So the brakes are done which is good progress. So I moved on to the fuel system. The carb was clean and dry so that was easy. But that's where the easy ended. I knew there was "fuel" in tank but all the lines are clogged. Well from the shut off valve to the tank. So it looks like I'm replacing...

I was finally able to get the rear hubs off. I bought a second puller and combined the two so it had five legs. Then got the big hammer out and after alot of hits it finally came off. Good thing I was able to get them off cause there was barely any grease in it. So now the only thing left is...

I was using a hub puller. It ended up braking a leg. I'm guessing the one I had laying around was a cheaper one. Sent from my SM-S918U1 using Tapatalk

Unless I missed something in the TM I didn't see anything about the other end of the axle to remove the hub. It just say to remove the wheel, dust cap, cotter pin then the nut. Then use hub puller and comes right off. But mine doesn't pop right off. The odd thing is the pads and hardware look...

It had shoes and everything in the drum and it all was free and moving. Don't know if the wheel cylinders were any good though. I was able to pull the 3 screws on the drum and drum came off the hub with no issue. The hub just won't come off the axle shaft Sent from my SM-S918U1 using Tapatalk

Current state Sent from my SM-S918U1 using Tapatalk

I was able to take the drums off the hub Sent from my SM-S918U1 using Tapatalk

And today was a set back. Rear hubs don't want to come off. They spin so I know the shoes aren't stuck but no luck with the hub puller. Pulled the drum off and pulled out the brake parts out. Used a slide hammer to see if it would move and nothing. So I'm stuck for now. Sent from my SM-S918U1...

Well there's no plate there. Looks like it was removed when they were doing whatever they were doing Sent from my SM-S918U1 using Tapatalk

I was just going off what I was told. It doesn't have any data plates on her. I don't remember if there is frame marking on these to find out year Sent from my SM-S918U1 using Tapatalk

I ended up with a new rescue this month. Got my hands on pretty clean 52 M38a1. Looks like someone started to restore but stopped. All the major parts, very little rust and the engine is free. Won't know if she starts up till I can clean out the fuel system. Going to go through all the brakes...