Search results

Sorry dont know the exact terminology but it was basically making cranking noises but wasnt actually fully starting. So was thinking it was related to that bolt that broke on the starter and had to rig another one. However, I went ahead and had wife spray the ether into the intake thing right in...

Solved: I got my wife to come spray a shot of ether as I was starting it and it finally turned over. So the hole I created on starter and all was not an issue and it seems the glow plugs just need to be changed out at this point. Thank You everyone for all your help!

Trying to include every detail I can think of, also on that hole I tapped out since the original hole is blocked by the tap, I used a Hex Head-Class 10.9 bolt to hold the three wires. Also, if there chance this is the problem will go borrow a welder and weld the original bolt back on the...

Also, the guy I purchased this from said it occasionally had trouble starting and had to use a squirt of ether to get it started. When I first got it last week was able to get it started without much trouble and drove it for couple days but then its gotten a lot colder here recently and then I...

I purchased the cutoff switch and when its off there is no power at all to the vehicle and won't even begin starting. Then when turn the cutoff switch to on it then gets power and the engine starts trying to start making that cranking noise but just never turns over and actually starts. So I...

Also included color arrows, the red is the original hole that the tap broke in, The yellow area was spot were there was already a small hole and just drilled it tad bit wider to then use a 1/4 tap and was able to create small bit of threads to then connect the two original wires, the tiny one...

Alright so I purchased a drill and tap as recommended and drilled the whole off and sprayed it down before using the tap then began tapping it and at the very end the tap snapped off so now it blocking the whole. I then noticed about an inch over there was another small hole so stripped the...

It was this one in the centre of the picture with the three wires going to it. I found someone who said they may be able to weld a bolt on but is there any way to get the car started until then?

Do I attach the two wire that where attached there prior to the grounding kit wire as well? I can go borrow a welder does that bolt just ground to the casing in which case just weld it somewhere on the casing? Thank You

So I was on the final bolt of the ground kit and so excited to be finishing and was going to tighten the bolt and before it even got tight it just broke off. Is there anything I can do at this point or do I need to buy a new starter? Its just a real bummer to come so close to finishing for the...