Search results

So the pin is just a shoulder bolt without a head. Instead of a head, it has two flats on it. But the head is fully inset into the bracket, so there must be a strange spinner wrench or something is wrong. Inside the roller, instead of oilite bushing, they used needle bearings. Mine are all...

I was able to get the roller apart. It is really strange how they are designed. Will post picture in next post. Sent from my iPhone using Tapatalk

No, the sun was going down. Plan to try again Saturday. Sent from my iPhone using Tapatalk

Thanks everyone. I think I will try the heat, a monkey wrench, and a big hammer and se what happens. I am not entirely sure how that thing goes together. I did not feel a head on the top. Did it break off or what should it look like? Sent from my iPhone using Tapatalk

Doing a winch transplant..... about half way through. The vertical roller (one that the nut is in the bottom) that is under the fuel tank does not spin. I don’t see a grease fitting for it. I see the nut under neath but no bolt head above it. I can’t figure out how the roller comes out or is...