Search results

It's not like I had a lot of choice.... Truck was broken and had to be repaired so I can drive it..... Besides, I'd rather spend $ on parts, fuel, etc than paying a mechanic (if I could even find one to do it) boatloads of $ to do it....

It was hard work but using a heavy duty transmission jack below and a chain drop and 2 ton come along from above, as well as taking the bed off made it doable by myself. Just had to take my time and it wasn't TOO bad... Just can't wait to build a pole barn so I can have a real shop work area...

Got the transfer case in today!!! Yay!!! I hadn't realized, but I think my transfer case must have been bad since I got it.... This one runs so smooth and quiet!!!!! The original one always made quite a bit of noise....:) Thanks everyone for your suggestions, they were VERY helpful! I...

Great thanks! Just a little nervous... ;-)

As you'll notice in the 3rd picture, the mount on the left side is horizontal and the left mount in the last pict is vertical... :?:

Decided to remove the bed to make it a little easier to access the parking break etc. And to pressure wash it so I'm not getting so much cr@p falling in my face... Noticed an interesting difference... the donor has a different mounting than the one I'm replacing... Will actually do the...

Great! Thanks everyone for your input. Great help!:D

Thanks BFR, I appreciate your input.

Great thanks for your input. New nuts and bolts is always a good idea (thanks for the reminder) specially for those hard to reach places! ;-) Thought about taking the bed off... would this make the job any easier, or be more trouble than it's worth? I'm getting started on this tonight...

Also, are there any 'specialty' tools that would make the job any easier/efficient?

Who would have that hardware readily available? I presume you mean the short shaft and u-joints. Also, when you say chain fall, you mean lowering it down instead of using the transmission jack?

Ok, I've got to replace the transfer case in my Deuce... Had the usual grinding, noice, pops out of gear etc... When changing the oil, found rather large chunks of metal that appear to be casings from a bearing... Thanks to my buddy Wade, I have a donor for it. Question, who has done a...