• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Fuel Gauge Indication Problem

BM59_Fan

New member
16
0
0
Location
Las Vegas New Mexico
The previous owner of my 710K Pinz installed a VDO fuel gauge on the dash. The problem I am seeing is that the gauge is indicating empty at half tank. I do not think the sender was changed. So could the problem be is it is a 12VDC gauge?

Any guesses and what should I look for?

Mike

Las Vegas NM
 

CliffSegar

New member
16
1
1
Location
Rockwood, TN
At half tank or 1/4 tank?
As a European vehicle, it goes to "R" when there is about 70Km of fuel left. That's their Reserve setting. There is no "Empty" mark.
 

CliffSegar

New member
16
1
1
Location
Rockwood, TN
Finally got out to look at mine with a volt meter. As you can see, it is just a bit over 1/2 tank and the gauge has 3.18 volts to the sense line.20160513_195556.jpgFuelGage.jpg
 

Sonarman

New member
4
0
1
Location
Sonoma, Ca
I just installed a VDO guage in mine. There is a small screw on side of guage to adjust it. Use plastic insulated screwdriver. The sending unit should be 0-100 ohms depending on full or empty. That can be checked with multimeter.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks