MEP-804A 24V Alternator no output and RPM Dropouts While Running

Zed254 said:

From Army TM 9 - 6 1 1 5 - 6 4 3 - 1 0. TMs for 804A here: https://www.steelsoldiers.com/showthread.php?148936-All-the-TM-s-you-need-to-work-on-the-MEP-804A

Battery Charging Alternator:
Manufacturer Hitachi
Model LR220-24
Rating 20 amps at 24 VDC
Protective Fuse 30 amps

$82 to $103 from a variety of suppliers: Search on model number.

Click to expand...

Looks like mine had an original.

I think there is two different NSN's, with the same part number. In any case, a non problem.

on the fuse it shows 32v, 30amp

Thanks again. I found it in the Technical Manual on a conversion update to circuit breaker. Now when I go back out I know where this is to look. I can also make sure the 60HZ is selected. I also see that the ammeter uses a real shunt. So I can double check the panel meter on the front for accuracy. It was in the green briefly one day last week and when I put voltmeter on cranking batteries I had 28.4V But in a few seconds the panel meter zeroed out again.

May ask what is TQG means? Sorry to ask.
Thanks

Tactical Quite Generator. Why should you hate to ask? The only dumb question, is the question not asked! Thats what we are here for.

Jaja it is true... thanks!

Guyfang said:

Tactical Quite Generator. Why should you hate to ask? The only dumb question, is the question not asked! Thats what we are here for.

Click to expand...