• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

6.2 inj pump what hole does the pin on the shaft go into?

epartsman

New member
264
0
0
Location
Jacksonville/Florida
I finally got around to installing my IP and I have been pouring over the TM's and have done a few forum searchs but does anyone know which hole on the timing gear the
pin on the IP shaft goes into? Is it the round or the oval hole? The round hole does not line up and the oval does not appear to be wide enough (through blind spot camera).
I am a big guy so getting around up there is tight and awkward for me and I do not wish to make a mistake I will regret.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks