Alternator question

[BlkH2O-Jarhead]

New alternator is in. I cannot remember where this one loose wire goes. Help please

 

[Mogman]

 

[BlkH2O-Jarhead]

View attachment 948987

Thank you

 

[BlkH2O-Jarhead]

Thank you

 

[BlkH2O-Jarhead]

Still not clear. The positive and ground are correct. The wires from the inside of the alternator are correct. They are shown on the diagram but on my alternator they are covered with a sealant. Still no indication of where the loose wire goes, shown in my photo. Open for advice. Thx

 

[Mogman]

Still not clear. The positive and ground are correct. The wires from the inside of the alternator are correct. They are shown on the diagram but on my alternator they are covered with a sealant. Still no indication of where the loose wire goes, shown in my photo. Open for advice. Thx

The loose wire should be 2A, dig all the silicone out (carefully) and look for the stud.
It MIGHT be possible that an alt. for a different application did not come with the AC tap but that is just a guess, should run and gen without it.