Carburator manual or drawing for M135 ?

[Brad]

I have taken the carb apart as far as I dare, and cleaned up pretty well. Really didn't see much signs of dirt. But it could have been something in the float valve I didn't see. Anyway, it would maybe help if I had an exploded view of how this thing goes together, and of course, how to adjust it? It has been years since I did this kind of stuff and I forget some. There is one place I am not sure I have it together properly?
I put it back on and it starts and idles, but was raining hard so we didn't take it out yet.
Also, are there gasket or rebuild kits available for these. It is a 2 barrel Holly, photo attached.
Thanks

 

[USMC 00-08]

Hi Brad. PM me your email address. I have three Powerpoints I can email you that will walk you through a rebuild. It has pictures, TM info , etc. For whatever reason, Powerpoints are not allowed to be uploaded here.

This place carried carburetor rebuild kits under part number K4125. I do not see it listed now, but I would call them if I were you.

Mike's Carburetor Parts

www.carburetor-parts.com

 

[Mullaney]

Hi Brad. PM me your email address. I have three Powerpoints I can email you that will walk you through a rebuild. It has pictures, TM info , etc. For whatever reason, Powerpoints are not allowed to be uploaded here.

This place carried carburetor rebuild kits under part number K4125. I do not see it listed now, but I would call them if I were you.

Mike's Carburetor Parts

www.carburetor-parts.com

.
Beam it to me and I will turn it into a PDF and post it and credit you with it...

 

[Brad]

Thanks guys, I appreciate this all very much. I checked with "Mikes" earlier and they do have the kit. But it will be great to see some actual directions on how to do things. My e-mail is :
longhunter1953@gmail.com
Thanks again

 

[Brad]

I been trying to figure out how to PM you, but can't fine it?

 

[USMC 00-08]

Beam it to me and I will turn it into a PDF and post it and credit you with it...

Email sent. Thank you!

I been trying to figure out how to PM you, but can't fine it?

Click on the person's username that you want to PM and click on Start Conversation.



This will come up.



Type message and click Start Conversation button at the bottom.