yolner
Active member
- 393
- 68
- 28
- Location
- Rockville, MD
So I installed the new pilot bushing, but now the clutch alignment tool won't fit inside. I don't know what I could have done wrong. I pulled the old one with a slide hammer and tapped in a new one.
Can I sand the inside of the bushing down to get the shaft to fit? If not what should I do differently next time? Is there a special tool you're supposed to use to install one of these?
Can I sand the inside of the bushing down to get the shaft to fit? If not what should I do differently next time? Is there a special tool you're supposed to use to install one of these?