crossover steering...

[Croatan_Kid]

Once again, great minds think alike!

 

[tsmall07]

Is the taper where the TREs go in the steering knuckles the same on both sides? In other words, if I were to make my own tie rod, could I use pass side TREs on both sides?

 

[chevycrew]

You could, but then you would have to take one end loose to adjust it.

 

[chevycrew]

Another source is www.Sky-manufacturing.com Great folks over there.

Dana 60 crossover, for $375, you provide the box.

I had a snafu when I was installing my kit. I received everything on a friday, but was missing the arm. UPS lost the 2nd package. I called Sky (owner)on friday, he shipped out a new arm to me, overnight, satuday, by 10am delivery.

He went way above and beyond.

 

[tsmall07]

www.Sky-manufacturing.com

you forgot an "n"

$375 is for the dana 44 (10 bolt) kit
its $675 for the dana 60 kit

 

[chevycrew]

fixed it....dang fingers

 

[tsmall07]

You could, but then you would have to take one end loose to adjust it.

Since the threads would be opposed, couldn't you adjust it by turning the tie rod?

 

[chevycrew]

You would need one end left hand thread and one end right hand thread, to be able to turn the rod to adjust.

Check out the threads on a turnbuckle for reference.

 

[tsmall07]

You're right. I had my mind criss crossed.

 

[tsmall07]

Another good source for this stuff is partsmikeparts.com

http://www.partsmike.com/store/store.php?crn=218&rn=1332&action=show_detail