- 10,874
- 793
- 113
- Location
- Appomattox, VA
Does anyone have any close up detailed pics of any dual M60 gun mounts? I've seen a few original pics of twin, side by side M60s, but nothing close up. Just want to get an idea how they are mounted.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
dual M60 machineguns
- Thread starter maddawg308
- Start date
Driver523
Member
- 528
- 23
- 18
- Location
- Cloverdale Mi
Here is a little different shot of a twin mount---I think they are the same ones that Eve had on it for a bit------twin M-60 mount-----Eve had em front right corner----Driver
Attachments
Driver523
Member
- 528
- 23
- 18
- Location
- Cloverdale Mi
Cry Uncle when ya had enough-----Driver
Attachments
- 10,874
- 793
- 113
- Location
- Appomattox, VA
The first pic in the latest post is kinda good, all the rest are too far away. Thanks, though,
Was hoping to come across a gun nut who has a pair mounted present day in his Class III collection.
Was hoping to come across a gun nut who has a pair mounted present day in his Class III collection.
Driver523
Member
- 528
- 23
- 18
- Location
- Cloverdale Mi
k---heres a few I dug out already----enjoy---------Driver
Attachments
Driver523
Member
- 528
- 23
- 18
- Location
- Cloverdale Mi
Better-----Driver
Attachments
David_4x4
New member
- 332
- 0
- 0
- Location
- North Texas
I have a friend that did this:
-Drill stem welded to metal plate for base
-The top of the stem was a fabbed up T section that had vertical posts on each end.
-The top of the ends of the T, he welded in pintle sockets.
-He can either then run 2 M142 cradles for both 60s or use 2 UPA/.30 pintle/platform mount.
Im not sure if this is remotely close to what they may have jimmyd up up nam, but it's stout and its hold his full auto pigs accordingly.
I also have a photo that I can try scanning of a piece of pipe with a piece of plate steel welded on top. Then 2 .30 pintles cut and welded on the top of the plate steel with platform mounts then attached to the pintle.
-Drill stem welded to metal plate for base
-The top of the stem was a fabbed up T section that had vertical posts on each end.
-The top of the ends of the T, he welded in pintle sockets.
-He can either then run 2 M142 cradles for both 60s or use 2 UPA/.30 pintle/platform mount.
Im not sure if this is remotely close to what they may have jimmyd up up nam, but it's stout and its hold his full auto pigs accordingly.
I also have a photo that I can try scanning of a piece of pipe with a piece of plate steel welded on top. Then 2 .30 pintles cut and welded on the top of the plate steel with platform mounts then attached to the pintle.
Last edited: