• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Inexpensive camper/utiliy box for m35a2

718
9
18
Location
Springfield Or
I worked this weekend on building what they call a basement in the RV industry. That's a fancy term for putting a box around the holding tanks and maybe some extra storage. I just put a insulated box around the tanks. The black water tank is inside the bed so it was the easiest. I just had to put some insulation around it and under the bed where it sits. I also inslated the floor and bed side next to it. Some how I forgot to do it before i inserted the bath room.


IMG_20140621_145234.jpgIMG_20140621_152111.jpgIMG_20140621_152653.jpgIMG_20140621_145242.jpgIMG_20140621_152700.jpgIMG_20140621_153704.jpgIMG_20140621_154055.jpgIMG_20140621_154112.jpgIMG_20140621_154717.jpgIMG_20140622_142220.jpg
 
718
9
18
Location
Springfield Or
Next I built a support under the grey water tank. It is designed to hang as installed. But I had to repair a small crack in the corner when I got it so I thought I would support most of the weight from the bottom. I used a couple pieces of 2 x 12 with some 1/2 foam to support the bottom. I them built a
1 1/2 foam box around it. I did this by filling the bed frame rail with insulation and surrounding the tank with foam sheets. It looked easy but being old and fat it was hard. Tomorrow I will be scraping hardened foam and painting around the pipes. The last step is to decide how to wrap the pipes.


IMG_20140622_142226.jpgIMG_20140622_150115.jpgIMG_20140622_152139.jpgIMG_20140622_162121.jpgIMG_20140620_151146.jpgIMG_20140622_175809.jpgIMG_20140622_180103.jpgIMG_20140622_172428.jpgIMG_20140622_172826.jpgIMG_20140622_173931.jpg
 
718
9
18
Location
Springfield Or
Installed more paneling.
 

Attachments

718
9
18
Location
Springfield Or
Panted and installed A/C cover. Wired in rear light. Installed ground fault plugs in the kitchen. Also if you are looking for a power inverter I would recommend a Durolast 1000 watt from Auto Zone. It is rated a 2000 watt surge 1000 continuous and is around a 100 bucks. I have it wired in so I can throw a couple breakers and power the truck from it. It won't run the A/C but it runs the microwave, coffee maker and any power tool I plug in but not necessarily at the same time.
IMG_20140704_123533.jpgIMG_20140704_132520.jpgIMG_20140704_143041.jpgIMG_20140705_150921.jpgIMG_20140705_150930.jpgIMG_20140705_153331.jpgIMG_20140705_153335.jpgIMG_20140705_153304.jpgIMG_20140705_152449.jpgIMG_20140705_152827.jpg
 
718
9
18
Location
Springfield Or
Worked on the counter top today. Trying to keep cost down I am using cheap pine furring strips. I am going to white wash the top and then apply several coats of polyurethane. I am planing the same for the floor but will probably use wider boards.

On a sad note the fan on my rooftop air seized up. I will have to pull the motor and repack the bushings with grease. Why did it have to happen when its so hot?
IMG_20140719_111520.jpgIMG_20140719_122357.jpgIMG_20140719_114817.jpgIMG_20140719_123305.jpgIMG_20140719_132949.jpgIMG_20140719_144115.jpgIMG_20140719_144100.jpgIMG_20140719_145640.jpgIMG_20140719_155424.jpgIMG_20140719_155430.jpg
 
718
9
18
Location
Springfield Or
Puttied and sanded counter top. Applied white wash and calked in sink and back splash. Then applied the first of many coats of polyurethane.

Total cost is about $75.00 That's less than a Formica counter top and I think it looks much better. Not so sterile if you know what I mean.

IMG_20140720_200702.jpgIMG_20140720_145020.jpgIMG_20140720_145028.jpgIMG_20140720_200642.jpgIMG_20140720_203147.jpgIMG_20140720_203549.jpg
 
Last edited:
718
9
18
Location
Springfield Or
Fixed the A/C. The fan motor is old enough that it dose not have sealed bearings. Sprayed a little brake clean in the oil cups and the motor freed up. Put some oil in and gave it a good workout today.

Pulled the draws and doors off the cupboards around the refrigerator and refaced with temped hardboard. Finished the ceiling up to the top bunk.

I also primed the bathroom door. Was going to paint it but when I opened the paint I found that at some point it had frozen and looked like cottage cheese.

IMG_20140725_082438.jpgIMG_20140726_113240.jpgIMG_20140726_123009.jpgIMG_20140726_123003.jpgIMG_20140726_125747.jpgIMG_20140726_131740.jpgIMG_20140726_182139.jpgIMG_20140726_182845.jpgIMG_20140726_183951.jpgIMG_20140726_185207.jpgIMG_20140726_151020.jpgIMG_20140726_170606.jpgIMG_20140726_170449.jpgIMG_20140726_170623.jpgIMG_20140726_171956.jpgIMG_20140726_110507.jpg
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks