M1009 Printed Circuit Board

[GunnyM1009]

maybe this will help your visual

 

[Dave Kay]

A thousand THANKS Gunny---

 

[GunnyM1009]

No problem Dave

 

[GunnyM1009]

So pulled the fuse for gen2 and its good. Switched bulbs and bulb holders around still a no go. I guess the next step is to pull down the relay holder and swap out the relays and see if it makes a difference. The only other thing I can think of might be fusible links somewhere.

 

[Warthog]

Before replacing parts test the power at the two pin plug at GEN2. Check the voltage ate the red and brown wires with the key off and the key on.

 

[GunnyM1009]

Already have. I actually replaced them on both alternators last week checked it again after gen2 light didn't work and voltages are good

 

[GunnyM1009]

Hey Warthog I had something baffle me earlier. At my plug on gen1 on the brown wire. If i test it unplugged from the gen with key on engine off i get 12.8v with it plugged in key on engine off i only gey 4.5v any idea why this is. Cant test with the engine on right now I am replacing the flexplate and starter tomorrow.