M52a2 transmission and transfer case seal replacement

[topo]

I'm working on my 67 M52a2 replacing some seals in the transmission put out shaft and transfer case in put also new seals and gaskits in the PTO . The space between them is like 9 inches. I'm using a torque multiplier and a 2 1/8 socket the torque multiplier I could not pull hard enough to unscrew the nut in the space I had I used a jack to pull and broke it free .The tool I made is to keep the yoke flange from turning .

 

[silverstate55]

Very nice! I use Milwaukee 18V impact wrenches (3/4” drive barely squeezes in between) and it helps get them off & on. Not much space to work with, great improvisation you did there. Thanks for sharing!