Dig
New member
- 25
- 0
- 0
- Location
- Merrill/Iowa
M915A-1 questions,
1. Manufacturer of the 5th wheel?
2. Is the adjustment procedure - close jaws on 2" pipe and tighten adjustment nut till jaws are snug on said pipe, then back off a turn or so (what I've been told)?
3. Are the adjustment nuts still available?
4. If the adjustment nuts are not still available will any proper sized and thread count (16) locknut pass DOT inspection?
Thanks for your help,
Dig
1. Manufacturer of the 5th wheel?
2. Is the adjustment procedure - close jaws on 2" pipe and tighten adjustment nut till jaws are snug on said pipe, then back off a turn or so (what I've been told)?
3. Are the adjustment nuts still available?
4. If the adjustment nuts are not still available will any proper sized and thread count (16) locknut pass DOT inspection?
Thanks for your help,
Dig
Last edited by a moderator: