• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M939 hub flip?

midcounty

Member
504
26
18
Location
Preston, MD
I am looking at using a set of 939 axles for a special project, but need to know if the rear hubs can be flipped. If so, what width would that make the axles, wheel flange to wheel flange? This is not the typical singling out of a truck, which would not require the flipping. For this project the must be flipped.
 

tie6044

Active member
Steel Soldiers Supporter
860
42
28
Location
Blaine, MN
If it is an A0 or A1 it will work but the overall width with be 4" narrower than the front. As far as I know you can not flip the hubs on the A2 series. If you need the actual width of the axles (wheel mount surface to wheel mount surface) I can get them, I have a set with the brakes off and the rear hubs flipped.
 

midcounty

Member
504
26
18
Location
Preston, MD
Tie6044, thanks for the info. A measurement would be very helpful. I can pick up a set of axles tomorrow, but with out a measurement I'm not sure if they will work.
 

tie6044

Active member
Steel Soldiers Supporter
860
42
28
Location
Blaine, MN
I guess I was a little off, they are 5" different. The front is 88 1/2" and the rear is 83 1/2".
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks