Saunders
New member
- 18
- 1
- 0
- Location
- Claremore, OK
Hello, I"m new to the forum here and had a question I hadn't seen addressed yet. I understand the Mep-003A has the ability to be switched and run to be either single or three phase. Is that simply because of the way it is wired to the VR or is the internal wiring in the gen head different?
What I was wondering, is if you had a bad generator head on a MEP-003A, could you use one from off a Mep-004 or 005? I understand the bellhousing would have to be adapted to fit, but are the internals the same other than being bigger sized?
What I was wondering, is if you had a bad generator head on a MEP-003A, could you use one from off a Mep-004 or 005? I understand the bellhousing would have to be adapted to fit, but are the internals the same other than being bigger sized?